Cornell CFC-E300TB User manual

Chopper CFC-E300TB

1
General Safety Precautions
1. The appliance should be used strictly in accordance with
these instructions. No liability can be accepted for any
damage caused by non-compliance with these
instructions, or any other improper use or mishandling.
2. Always unplug the appliance from the Mains electrical
supply outlet before cleaning it or when not in use.
3. The appliance should never be left unattended while it is
connected to the mains electricity supply.
4. Keep the appliance out of reach of children.
5. Do not allow the cord to hang down over edges.
6. Do not operate the appliance with damaged cord set or
plug. Any repairs should always be done by an
experienced technician or by an authorized service centre.
7. Do not immerse the appliance in water.
8. Always place the appliance on a flat sturdy surface. When
moving appliance, always be aware not to touch hot
surfaces, or possible spillage of hot liquids it may contain.
9. Do not unplug the appliance by pulling the supply cord.
10. An electrical appliance should not be used if:
The power supply cord is damaged;
The appliance has been dropped at any time, or there
are visible signs of damage;
The appliance is leaking.

2
Parts Identification
Specifications
Model No.
CFC-E300TB
Rated Voltage
220-240V~
Rated Wattage
300W
Frequency
50/60Hz

3
How to use Your Chopper
1. Chopper
Place the chopper cup on a dry and level horizontal surface.
Put the chopping blades into the chopper cup.
(Note: Do not use blender).
Put the meat (cut into small pieces with 10-20mm thickness,
without bone and muscle) into the chopping cup (the
volume of food should not be more than 300g) and then
close the chopper cover with the base connection.
When the food has been cut into desired pieces, turn off the
unit. After the motor stops running, remove the base and
cover to take out the food.
2. Making Fruit / Vegetable Sauce.
Place the chopper cup on a dry and level horizontal surface.
Put the chopping blades into the chopper cup and then put
on blender as shown in the picture below.
Remark: When doing milk shake, use the water inlet hole to
pour the water or the milk into the cup.
Before putting the food, cut it into (20-25mm) cube size.
Then place it into the chopper cup and make sure the
volume is not over 2/3 of the cup. Add some water into the
cup and ensure the water volume must be enough to make
sure the food can be stirred smoothly. Close the chopper
cover with the base connection.

4
When the food has been cut into desired pieces, turn off the
unit. Wait until the motor has stopped running before
removing the food out of the cup.
Note : The motor is equipped with a protective setting
which will turn off the unit automatically when
the motor is over heated. It can be re-operate
after the motor has been cooled down.
Troubleshooting
Problem
Possible Causes
Remedy
Motor does
not operate
Safety lock is not
secure
Reassemble the
container and connect
with the base correctly
Motor
overheat or
presence of
bad odour
Too much food or
working time too
long
Reduce the food and
run it again after the
unit cools down. It
takes approximately 10
minutes for the unit to
cool down
Meat texture
is not fine
after
chopping
Too much
muscles or too
much meat
Remove muscles or
reduce the volume of
meat

5
Care and Cleaning
1. Switch the appliance off and remove the plug from the
wall socket.
2. Do not use abrasive creams, steel wool or scouring pads.
3. Clean the appliance with dish washer detergent and wipe
with dry cloth. Store it in dry and cool place.
WARNING: THE CHOPPER BLADES ARE SHARP.
EXERCISE CAUTION WHEN CLEANING.

6