Costway HV10063 User manual

Single Sofa Chair
HV10063
USER’S MANUAL
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.

Before You Start
Read each step carefully before starting. It is very important
to ensure each step followed in correct order, otherwise
assembly difficulties may occur.
Most of board parts are labeled or stamped on the raw
edges. Have a check to make sure all parts are included.
Work in a spacious area, preferably on a carpet close to
where the unit will be used.
Keep the handtools close at hand. Do not use power tools to
assemble your furniture. They may scratch or damage the
parts.
02

WARNING
●This product has been designed for seating one (1) average adult.
To prevent injury and damage to this unit, PROHIBIT jumping on it.
●This product is designed for home use and not intended for
commercial use.
●Children under the age of 5, small infants and babies should not
sleep alone on this product for safety reasons.
●Recommended # of people needed for handling: 2 (however it is
always better to have an extra hand.)
●THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY
INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
PARTS
1x1
Seat Body
2x1
Backrest
3x2
Arm
(Stored under
the seat body)
4x1 5x2 6x4
LegPillowBack Cushion
03

Cx6
Nut
Ax1
Spanner
Bx6
Threaded Rod
Dx6
Washer
Ex6
Spring Washer
HARDWARE
M8 x 70mm
M8 x 22mm M8
M8
14mm
24
3
3
A x B x 6 C x 6
6 x 4
D x 6 E x 6
01
HARDWARE
Storage space under
the seat body
Carefully unpack parts/hardware from box and storage of
seat body, place on a clean flat surface.
04

C
E D
A
3
3
02
03
× 6
B
B 3
Screw in three threaded rods into
pre-drilled holes of armrest by hand until
about half of the thread is exposed.
Repeat steps for other armrest.
Locate pre-drilled holes on the side of sofa body and match the
orientation with the correct armrest.
Now, carefully join armrest (with the three threaded rods exposed)
with sofa body by aligning and going through the three pre-driled
holes at the side of sofa body.
Open compartment cover underneath the sofa base and secure all
three threaded rods with flat washers, spring washers and nuts from
inside with spanner, making sure there is no movement.
Repeat step for other armrest.
× 6 A C
× 6 × 6
D E
05

04
05
36
6
3
6
6
Align all four legs onto pre-drilled holes and secure by hand.
Please avoid overtightening.
Insert backrest metal plates to both arms as shown below.
Ensuring it is correctly in place.
2
3
3
66
6
06

06 Secure both back cushions by locating the zipper end.
Fasten both sides and continue all the way to the end.
Flip the pillow into position when finished. Place accent
pillows as desired .
INSTALLATION COMPLETE :
4
2
3
3
66
6
07

Care and Maintenance
Use a soft, clean cloth that will not scratch the surface when dusting.
Use of furniture polish is not necessary.
Should you choose to use polish, test first in an inconspicuous area.
Using solvents of any kind on your furniture may damage the finish.
Never use water to clean your furniture as it may cause damage to the
finish.
Liquid spills should be removed immediately. Using a soft clean cloth, blot
the spill gently. Avoid rubbing.
Check bolts/screws periodically and tighten them if necessary.
It is best to keep your furniture in a climate-controlled environment.
Extreme temperature and humidity changes can cause fading, warping,
shrinking and splitting of wood.
It is advised to keep furniture away from direct sunlight as sun may
damage the finish.
Proper care and cleaning at home will extend the life of your purchase.
Following these important and helpful tips will enhance your furniture as it
ages.
Further advice about wood
furniture care
08

Please give us a chance to make it right and do better !
Contact our friendly customer service department for help first.
Replacements for missing or damaged parts will be shipped ASAP !
Contact Us !
Do NOT return this item. US:[e-mail]
UK:[e-mail]
AU:[email protected]
US office: Fontana UK office: Ipswich AU office: Truganina