Cozzia CZ-730/Qi User manual

ASSEMBLY INSTRUCTIONS CZ-730/Qi

Open box 1 and remove all the packing materials. Take the chair out of the box. Collect all the accessories and
put them aside.
Massage chair arrives in three boxes. As pictured below.
2
1
56.7"x34.4"x34.6"
COLOR:Espresso & Vintage Copper
Espresso & Vintage Copper
Base & Backrest
1
1
178.2
217.8
CZ-730/Qi-BEVC
COLOR:Espresso & Vintage Copper
Side Panels & Rear Cover
2
45.1"x13.4"x27"
15.4 lbs
24.2 lbs
CZ-730/Qi EVC
Espresso& Vintage Copper
4
2
CZ-730/Qi-S EVC
35.6"x28.1"x24.4"
66.0 lbs
81.4 lbs
CZ-730/Qi EVC
Espresso & Vintage Copper
COLOR:Espresso & Vintage Copper
Footrest & Head Unit
3
4
3
CZ-730/Qi-F EVC

Engage the joint of the footrest actuator and footrest. Then join them together with the bolt and lock with the cotter
pin. As pictured below.
Caution: The bolt must be inserted right-to left and the flat side must be up .
Open box 3 and remove the packing material on the top. Take out the footrest and the speaker unit.
3
Take off three cotter pins and three bolts, put them aside the chair. Then move footrest close to the chair.
4
Move the footrest close to the chair. Zip the zipper to join the two fabrics together. As pictured below.
6
7
Connect footrest wire connectors and attach the connectors onto the front cover. Then connect the 4-way air hose. As
pictured below.
Caution: One wire connector has a cap. After the connector has been connected the cap must
be screwed.
5

Engage the joints of the footrest and the base. Lift footrest up to align the holes on the joints. Then insert the bolt
and lock with the cotter pin.
8Attach the speaker unit to the backrest. Make sure the metal plates engage to the bolts. Connect the wire connector
on the left side. Fix the speaker unit with screws. There are three screws on each side. As pictured below.
10
Zip the zipper to join the footrest and seat pad. Then remove the cable tie on the zipper head. As pictured below.
9

Open box 2 and take out the side board, decoration strips and rear cover.
Move the side board cover close to the side board and align the snap joints. Pinch the lower side board to clamp the
snap joints. Knock the edge of the side board cover to make sure all of the snap joints are clamped.
11
Fix the side board cover with three cross recessed pan head screws. As pictured below.
12
12
Attach decoration strips.
Align the snap joints first. Knock the decoration strip to clamp the snap joints. Fix it with a cross recessed pan head
screw. As pictured below.
Caution: Clamp the front snap joint first. then the rear snap joint.
13

Attach the rear cover of the backrest. Use two cross recessed pan head screws to fasten it. As pictured below.
14
Remove the packing materials of the Ipad mini holder. Connect the chair to power supply. Unlock the main switch
first, and then turn on the power switch. Now the chair is ready to start.
15
TEL: [phone]
FAX: [phone]
[email protected]
WWW.COZZIAUSA.COM
861 S. Oak Park Road,
Covina, CA 91724