Cozzia CZ-357 User manual

CZ-357

Installation Instructions
Open box 1 and remove the packing materials. Take the chair out of the box. Collect all the accessories
and put them aside.
1
Adjust the chair position. Use the power cord to connect the chair to a power supply and turn on the power
switch. The chair will move to the home position. Now disconnect the power cord.
2

Connect the wire harness and air hose. Connect the wire connectors and screw the cap tight. Then
connect the air hose.
Caution: After the wire connectors have been connected the cap must be screwed tight.
6
Remove the cotter pins and bolt on the link rod of the chair. Locate the cotter pin and bolt on the
link rod. Take them off and put aside.
3
Open box 2. Take the footrest out and remove packing materials.
4
Connect footrest to base. Move the footrest close to the chair. Engage the link rod with the footrest joint,
then insert the bolt and lock with the cotter pin.
5Connectors of four-pin plug connect together Connectors of thirteen-pin plug connect together

Zip the zipper between the seat pad and footrest cushion.
8
Turn on the chair. Connect the chair to a power supply and turn on the power switch. The chair will now be
ready to start.
9
Attach the footrest onto the base. There are two bolts on the base. Connect the footrest to the bolts.
7