CP TECHNOLOGIES WBR-3800 User manual

LevelOne
WBR-3800
MobilSpot™ Portable Wireless Hotspot
Quick Installation Guide

Default Settings
IP Address 192.168.0.1
User/Password password
Wireless Mode Enable
SSID WBR-3800
Security None
This guide covers only the most common situations. All
detail information is described in the user manual.

To start installation, connect the WBR-3800 MobilSpot™
to your LAN network.
Note: DO NOT connect the MobilSpot™ to power before performing the
installation steps below.
Step 1:
Attach the antenna by screwing it in a clockwise
direction.
Once secured, position the antenna in an upwards
position to ensure optimal reception.

Step 2:
Insert your 3G PC Card (either 16bit or 32bit) or plug a
3G USB Modem to the MobilSpot™.
Note: The WBR-3800 MobilSpot™ is designed to work with either
UMTS or EVDO and even HSDPA 3G modems. Please refer to your
service provider for detailed feature information.
If you also have an ADSL or Cable Modem, connect the
modem to the WAN port.

Step 3:
Insert the Ethernet cable into the LAN Port on the back
panel, and an available Ethernet port on the computer
you wish to use to configure the unit.
Note: After configuration is complete, you may wish to connect the LAN
port to a Switch to share the Internet connection over wired network.
We recommend Level One‟s FSW-0511 - 10/100Mbps 5 Port Switch.

Step 4:
Connect the Power Adapter
a. The Power LED will turn ON to indicate power
has been applied.
b. Other LEDs will flash ON and OFF as the
MobilSpot™ performs initialization and
connection process.
c. When complete, the following LEDs will illuminate
green: 3G, WAN, LAN and WLAN.

Step 5: Using the Easy Setup Utility
1. Install the Easy Setup Utility from CD. After
installation is complete, you can execute it from the
Start Menu.
2. Configure the settings by the following steps.
Select the Language, the click “Next.”

3. You can select Quick Mode to run the Step-by-Step
Wizard, or use Advanced Mode to access the Web
Based Configuration of the router.
Note: Please see User Manual for usage instructions
4. Check the items are completed before proceeding.

5. Enter your Wireless settings
6. Auto Detect your WAN Service.

7. In this case, DHCP WAN Type is detected.
8. Easy Setup is complete.
9. Click “ Finish” to complete the installation.