
2
WARNING:
1) Requires 3 “AAA” batteries (Included).
2) Do not mix old and new batteries.
3) Do not mix alkaline, standard (carbon zinc), or rechangeable (nickel-cadmium) batteries.
877-852-8164
AFTER SALES SUPPORT 45948
Unpacking the Game
Unpack your new dartboard carefully, making sure all parts are included. The following components
are included in this set: • 1 Electronic Dartboard / • 6 Darts (unassembled) / • Owner’s Manual
Batteries
This dartboard requires 3 AAA (1.5 volt) Batteries to operate. BATTERIES ARE INCLUDED. Do NOT
mix old and new batteries and do not mix alkaline, standard (carbon zinc), or rechargeable (nickel
cadmium) batteries. Do not dispose of batteries in fire, batteries may explode or leak.
Setup / Mounting Instructions
Choose a location to hang the dartboard where there is about 10 feet of open space in front of the
board. The “toe-line” should be 7 feet 9 1/4 inch from the face of the dartboard. Locate a wall stud
and place a mark 75 inches from the floor. This mark is for the top screw hole. For the bottom two
screws, you will measure down 12.5 inches from the top mark you just made and make a temporary
reference mark. (do not drill a hole for the temporary reference mark) You will need to place a mark
5.3 inches to the left of that reference mark point for the bottom left screw hole and then make
another mark 5.3 inches to the right of the original reference mark for your bottom right screw hole.
Insert mounting screws in the center of the marks you made. (do not drill into the TEMPORARY
REFERENCE MARK)
WARNING: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
WARNING:
This is not a child’s toy. Adult supervision is required for children playing this game. Please
read instructions carefully. Proper use of this can avoid damage or injury.