Crescent C2000 Parts list manual

Usage Instructions
THE CRESCENT
C2000 BODY LIFT
4975 West Main Street. • Tupelo, MS 38801
662-844-8779 • 1-888-856-4516 • Fax [phone]
www.crescentsales.com • email: [e-mail]
LIMITED
WARRANTY
The C2000H (Hydraulic) and the C2000E (Electronic)
Body Lifts and their accessories are guaranteed
against defect in material and workmanship for a
period of ONE YEAR from date of purchase.
Limited to repair or replacement at
Crescent Sales discretion.
Replacement Parts
MAIN BODY FRAME
& ACCESSORIES
Cradle (1)
Arm (1)
Support (1)
Brace (2)
Leg (1)
3” Caster (7)
6’ Strap (4)
“S” Hooks (8)
Ball & Pin (3)
JACKS (dependant on lift model)
Hydraulic (1)
Electronic (1)
ELECTRONIC MODEL ONLY
Remote Control (1)
Battery (1)
AC Adaptor (1)
BOLTS, NUTS & WASHERS
3/8” x 3” Grd. 6 Hex Head Bolts (10)
1/2” x 3-1/2” Grd. 6 Hex Head Bolt (1)
12mm x 87mm Allen Head Bolt (1)
12mm x 65mm Allen Head Bolt (1)
3/8” Washer (24)
1/2” Washer (6)
12mm CenterLock Nut (2)
3/8” CenterLock Nut (10)
1/2” CenterLock Nut (1)
Phillips Head Screws Electronic Only (3)
07/10
Arm
Cradle
Support
Leg
3” Caster
Braces
Electronic Shown
READ THIS MANUAL BEFORE USING THIS PRODUCT.
This manual is designed to prepare and instruct the user in the
safe operation of the Crescent C2000 Body Lift. If there are any
instructions that are not understood, please call our customer
service department at 1-888-856-4516.

!
TO RAISE HYDRAULIC LIFT
1 Tighten RELEASE VALVE clockwise
with tip of JACK HANDLE.(A)
2 Begin raising by pumping
JACK HANDLE in a smooth up and
down motion.(B)
TO RAISE ELECTRONIC LIFT
1 Twist and pull out emergency stop(C)
2 Push and hold UP BUTTON on
remote until lift has attained proper
height, then release to stop.(D)
TO LOWER HYDRAULIC LIFT
1 Slowly loosen RELEASE VALVE
counter-clockwise with tip of
JACK HANDLE, turning back
clockwise to lock into place.(E)
TO LOWER ELECTRONIC LIFT
1 Make sure emergency stop is
disabled.(F)
2 Push and hold DOWN BUTTON on
remote until lift has lowered to proper
height, then release to stop.(F2)
CAUTION: •Never raise arm above parallel to the floor, doing so
could cause lift to tip, causing damage or injury.
•Never lift using only one end of CRADLE.
•Always lower slowly.
LIFTING A CASKET
1 Feed 2 SIX FOOT STRAPS into
buckle at the same time(J). Then
proceed with same directions used in
lifting a body.
AB
E
I
J
CD
G
ATTACHING BUCKLE TO 6’ STRAPS
1 Feed SIX FOOT STRAP end from
the underside into buckle.(G)
2 Loop STRAP end over BUCKLE
TEETH back through buckle.(H)
H
!
HOW TO USE STRAPS
1 Place STRAPS under body.*
2 Hook both “S” HOOKS into slots
on CRADLE.(I)
•Never lift using only one end of CRADLE.
3 Pull tight at buckle for desired
length.
FF2
TO MOVE THROUGH DOORWAYS
1 Making sure CRADLE is supported, pull BALL &
PIN from CRADLE. Raise ARM to horizontal
position.Then, hang CRADLE on ARM.
2 Pull both BALL & PINS from LEGS and flip up.
3 Lift is now ready to roll through doorway.
Electronic Model Shown
*STRAP
SLIDER
For use with large bodies where it is difficult to place strap under body. Attach “S” hook to
Strap-Slider as shown above. Then, turn Strap-Slider over with strap side down and slide
under body. From opposite side, grab Strap-Slider & pull hook through to the other side.