
Adding your Fingerprints:
(2 Fingerprint sets are to be set up on the initial scanning set up)
Step 1: Press the fingerprint scanner until the blue LED turns solid blue.
Step 2: Press the same fingerprint several times in different positions until
the LED turns green.
Step 3: When the green LED light is on, press a second fingerprint several
times until the green LED turns off.
Step 4: If the LED is flashing red, the fingerprint registration has failed.
Follow the above steps again.
Adding Additional Fingerprints:
Step 1: Unlock the lock with an already saved fingerprint and keep the
finger in place until LED turns blue.
Step 2: Press the scanner with the fingerprint you wish to scan several
times in different positions until the green LED light turns off.
Step 3: If the LED is flashing red, the fingerprint registration has failed.
Follow the above steps again.
Reset Factory Settings:
Step 1: Unlock the lock with an already saved fingerprint.
Step 2: Press the scanner again with an already saved fingerprint and
keep finger in place until LED flashes red.
Step 3: With the LED flashing red press the scanner with the same finger until
the LED turns green and all prior saved fingerprints are deleted.
Page 2
Warning on Water Resistance:
Ensure the lock in not submerged in liquid. A product with an IPX2
rating is protected from water droplets when tilted at a 15° angle.