Crestron DM-NVX-360 User manual

DM-NVX-360/DM-NVX-363
DM NVX® 4K60 4:4:4 HDR Network AV Encoder/Decoder
DocType - 8633B
(2055216)
08.22
Getting Started
Scan the QR code to view the Quick Start Guide.
www.crestron.com/docs/8634
For additional information about the DM-NVX-360,
visitwww.crestron.com/model/6511006.
For additional information about the DM-NVX-363,
visitwww.crestron.com/model/6511008.
The original language version of this document is
U.S. English. All other languages are a translation
of the original document.
Certification and Compliance
Regulatory Model: M201910003
Federal Communications Commission (FCC)
Compliance Statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following conditions:
(1) This device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
lReorient or relocate the receiving antenna.
lIncrease the separation between the equipment
and receiver.
lConnect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
lConsult the dealer or an experienced radio/TV
technician for help.
Industry Canada (IC) Compliance Statement
CAN ICES-3 (B)/NMB-3(B)
As of the date of manufacture, the product has
been tested and found to comply with
specifications for CE marking.

Crestron Electronics, Inc.
15 Volvo Drive, Rockleigh, NJ 07647
Tel: 888.CRESTRON
Fax: [phone]
www.crestron.com
Product Information - Doc. 8633B
(2055216)
08/17/22
This product is listed to applicable UL® Standards
and requirements tested by Intertek® services.
Ce produit est homologué selon les normes et les
exigences UL applicables par Intertek Prestations
de service.
The product is a class 1 laser product. It complies
with safety regulations of IEC 60825-1, FDA 21 CFR
1040.11 and FDA 21 CFR 1040.10.
WARNING: Visible and invisible laser radiation when
open. Avoid direct exposure to beam.
NOTE: Plug the included dust cap into the optical
transceiver when the fiber optic cable is unplugged.
The Waste Electrical & Electronic Equipment
(WEEE) directive marking on a product indicates
that it should not be disposed of with general
waste. Instead, you are encouraged to reuse or
recycle the product in accordance with Directive
2012/19/EU of the European Union. Proper disposal
of this product will help prevent potential negative
effects on the environment and human health,
which could otherwise be caused by inappropriate
waste handling. Penalties may be applicable for
incorrect disposal of this waste, in accordance with
your national legislation. For information about
recycling this product, please contact your
household waste disposal service, your original
distributor, or Crestron.
Legal
The product warranty can be found at
www.crestron.com/warranty.
The specific patents that cover Crestron products
are listed at www.crestron.com/legal/patents.
Certain Crestron products contain open source
software. For specific information, visit
www.crestron.com/opensource.
Crestron, the Crestron logo, and DM NVX are either
trademarks or registered trademarks of Crestron
Electronics, Inc. in the United States and/or other
countries. The HDMI logo is either a trademark or
registered trademark of HDMI Licensing LLC in the
United States and/or other countries. Intertek and
the Intertek logo are either trademarks or
registered trademarks of Intertek Group in the
United States and/or other countries. UL is a
trademark or registered trademark of Underwriters
Laboratories, Inc. in the United States and/or other
countries. Other trademarks, registered
trademarks, and trade names may be used in this
document to refer to either the entities claiming
the marks and names or their products. Crestron
disclaims any proprietary interest in the marks and
names of others. Crestron is not responsible for
errors in typography or photography.
©2022 Crestron Electronics, Inc.