Criterion TUSCANY1800 Installation guide

- Please follow these assembly instructions as it will save you time, make
assembly easier and prevent possible damage to your new unit.
- Correct assembly is your responsibility.
- We strongly recommend that the unit is assembled on a soft surface such
as carpet or blanket.
as power tools can strip threads if over tightened.
- When moving this furniture item, always carry the unit. Dragging or
VOLGLQJWKHXQLWFRXOGGDPDJHWKHXQLWDQGWKHµRRUVXUIDFH
Assembly Instruction Manual
MODEL NO.: TUSCANY1800
TUSCANY2000
- We suggest the use of hand tools only to tighten all screws aQG´WWLQJV
500
170170
1700
330
385
2000
400
600600
130
740
115 - 179
310
170
330
385
1500
400
600
1800
600
500
170
130
540
115 - 179

arrowhead on cam points
toward to the hole on the
panel edge.
arrowhead on cam points
toward to the hole on the
panel edge.
x4pcs

arrowhead on cam points
toward to the hole on the
panel edge.

1. HAND TIGHTEN THE BOLTS (PART 29) INTO THE LEGS THEN BACK OFF 3-4 FULL TURNS
2. SLIDE CROSS RAIL (PART 10) ONTO BOLT (PART 29)
3.TIGHTEN NUTS (WITH PART 27 IN PLACE) WITH SPANNER PROVIDED (PART 30)

20
22
19
21

NOTE: For gyprock walls
ensure you locate the
studs or use appropriate
xings to attach the straps
to the wall. (Also see Step 10)
Use a screw driver to
fasten the screws
(Part 31) into the wall.

Use a screw driver to
fasten the strap (Part 38)
onto the bracket at the
back of the cabinet.
Ensure the straps are
tight, once the
cabinet is placed into
position.

SURFACE CARE INSTRUCTIONS
A little care and attention will extend the life and good looks of your furniture. Take care
when using materials which might spill, or be sharp or abrasive, on the surface of your
furniture.
Normal Cleaning: For normal cleaning use a soft, dry, clean cloth.
Glass Cleaning for Frosted Glass: Do not use glass cleaner or solvent based cleaners on the
surface of the glass that has the frosting effect on it.
Normal Glass Cleaning: You may use normal glass cleaning products on all other types of
glass. Use a soft non-abrasive cloth to remove light dust and finger prints.
Vinyl & Speaker Cloth Cleaning: Under no circumstances should any abrasive materials be
used on this surface, as it will result in unrepairable damage.
Do not use solvents, solvent based cleaners, scouring pads, steel wool, furniture wax or
scrubbing brushes.
Only use a slightly damp, soft, clean cloth on this surface if cleaning is needed. Do not scrub.
CAUTION
As with all furniture, this unit should not be exposed to direct sunlight, extreme
temperatures or moisture, as this can result in non-reparable damage.
Note: The sooner a spill or mark is cleaned, the easier it will be removed.
Customer Service
FOR ALL MISSING OR FAULTY PARTS: PLEASE RE-CHECK YOUR PACKAGING TO ENSURE THAT PARTS ARE MISSING THEN CONTACT THE
STORE YOU PURCHASED THE ITEM FROM.
THE STORE WILL NEED THE FOLLOWING INFORMATION…..
- COPY OF YOUR PURCHES SLIP/RECEIPT
- MODEL NUMBER OF THE UNIT PURCHASED
- DESCRIPTION/PART NUMBER OF THE MISSING OR FAULTY PART
- QUANTITY OF THE PARTS NEEDED
If for whatever reason you cannot get in contact with the store, please get in contact with Criterion direct at
http://www.rvm.com.au/contact.
Product of RVM Australia
11 Tamara Drive, COCKBURN CENTRAL
Perth, Western Australia 6164
PH: 08 9417 9944

WARRANTY POLICY
1. Nothing in this Warranty affects the Consumer’s rights under the Australian Consumer law. The
benefits to the Consumer under this Warranty are in addition to the rights and remedies of the
buyer under any Consumer Guarantees. The Australian Consumer Law requires that we confirm that:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or
replaced if the goods fail to be of acceptable quality.
2. Subject to Clause 1, the Seller warrants that CRITERION branded products will be free of
manufacturing defects and will perform to the Seller’s specifications subject to the following clauses.
3. The benefit of this 12 Month Warranty extends only to the owner of the property in which the
Products manufactured or supplied by the Seller are installed and used by the owner for the
duration of the Warranty Period.
4. If within the Warranty Period a manufacturing defect is discovered in the Product, or the Product
fails to perform to the Seller’s specifications as a result of some defect in material or workmanship,
then the Seller will replace or repair the goods under Warranty or refund the purchase price paid by
the consumer (except if the failure is a major failure)
5. The Warranty does not apply to Product that:
a.) Has failed due to excessive wear and tear beyond what is considered to be reasonable.
b.) Has been misused or neglected.
c.) Has been damaged accidently or by acts of God including fire and flooding.
d.) Has been used or operated contrary to operating or maintenance instructions.
e.) Has been damaged in transit from the Sellers store to the buyer, either by the buyer or a third
party authorised to act for the buyer.
f.) Was incorrectly assembled or installed
6. In order to make a claim under the Warranty, the Owner must provide proof of purchase in all
cases.
7. The seller will examine any returned Products and if the Seller determines that there is an
apparent defect through no fault of the Owner, the Seller will:
a.) Make note of the Owner’s contact details including the Owner’s telephone number which the
owner can be contacted during business hours, postal address and e-mail address.
b.) Make note of the defects reported by the Owner.
c.) Take back the defective goods from the owner and determine within a reasonable time through
dialogue with the Seller whether the goods are defective.