Croker Enforcer II User manual
“The Enforcer II” Valve Testing Device“The Enforcer II” Valve Testing Device
User ManualUser Manual
Model 8072-VTD-25-V2
Introduction
periodically after, ensuring they are free from defects and meet the system’s hydraulic requirements. The “Enforcer II” valve testing
meet the test requirements.
8072-VTD-25-V2 Parts List and Diagram
Standard Unit Components:
• 8072VTD25-LV-V2
NST threaded outlet, gauge assembly, stability base with handle, and a detachable elbow. The testing device measures the
kinking. The elbow can also angle the discharge of the water from the unit when connected to the swivel gate valve’s outlet.
• 5155CB01
level.
Optional Accessories:
• 8072-CASE-V2
Replacement Parts:
• 8072-QDGA-V2
• 8072-PSI-GA-V2
• 8072-GPM-GA-V2
• 8072-QDGA-V1
“The Enforcer II” Valve Testing Device“The Enforcer II” Valve Testing Device
User ManualUser Manual Model 8072-V2
Page 1
Inlet Outlet
5155CB01 Throttling
Gate Valve
Aluminum body with
directional arrow
Base with handle
8072-CASE-V2
Gauge Assembly
30° Elbow
Page 2
Operation
Important Note: Scaling and other sediments can damage the internal components of the device. Flush the test connection
water supply free of debris before each use. Always reference the applicable testing standard(s) and check with local codes
and ordinances for amendments or exceptions.
2. Fully close the swivel gate valve and attach it to the discharge side of the body.
6. Use a wrench to fasten all connections securely. No leaks should be present during testing.
test connection fully open, the pressure gauge shows the static outlet pressure.
process until the valve is set correctly and measurements are recorded.
9.
and drain plugs, and post results as required. Follow the VTD’s maintenance instructions when all testing is complete.
Maintenance
•
assembly to freezing temperatures, especially when wet.
•
the optional case to protect the gauges from damage.
•
•
“The Enforcer II” Valve Testing Device“The Enforcer II” Valve Testing Device
User ManualUser Manual Model 8072-V2
Gauge Calibration
replacing the gauges on an annual basis.
Warranty
shipment. This warranty is limited to the original purchaser and applies to products deemed inoperable or unusable due to defects
Disclaimer
contained herein or occurring during use of this product.
“The Enforcer II” Valve Testing Device“The Enforcer II” Valve Testing Device
User ManualUser Manual Model 8072-V2
Page 3
This manual suits for next models
1
Table of contents
