Crosswater Waldorf US-WF6060 User manual

Waldorf LED Mirror
US-WF6060
Installation Instructions

THIS FIXTURE MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN.
Read these instructions thoroughly prior to installation. Improper installation voids the product warranty.
Failure to follow instructions could result in serious injury or death.
Keep these instructions for future use and reference.
Installed products cannot be returned.
If you experience any problems with your mirror, contact your dealer directly.
This product uses non-replaceable LED lamps.
DANGER: Risk of personal injury. To avoid possible electrical shock, the electricity must be turned off at the
circuit breaker or fuse box before attempting any installation procedure.
DANGER: Risk of personal injury. To avoid possible electrical shock, the outlet box must be properly grounded.
Observe all local electrical codes and building codes.
This fixture is for indoor use only.
This product must be connected to a grounded metal, permanent wiring system, or an equipment-grounding
conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on
the product.
This luminaire must be mounted or supported independently of an outlet box. Make sure electrical connections
are wired correctly. Power and neutral wires must be connected to the luminaire disconnect. Insert the power wire
into the black colored insert and the neutral wire into the white colored insert. The ground must be connected. Do
not defeat the safety purpose of the grounding wire inside the chassis. The chassis must be grounded to avoid
possible electrical shock.
Prior to installation carefully unpack and inspect the fixture for any damage that may have occurred during
transport and that all required parts are supplied. Note: Damage claims cannot be made during or after
installation.
Front View Back View
Screw x6
Wall anchor x6
Mounting bracket x2
23-5/8"
23-5/8"
IMPORTANT SAFETY INSTRUCTIONS

A
1. MIRROR MOUNTING
WARNING: Check for any hidden pipes and cables, electric or otherwise, before drilling holes in a wall.
Before mounting, identify the mirror location on the wall. Drill marks should be measured from the edge of the
mirror not from the edge of the mounting bar. The fixture must be installed with the mounting bracket and
the 6 screws supplied. Use wall anchors or suitable stud wall fitting (not supplied). See individual product for
mounting hole locations.
Check to make sure the mounting brackets are level.
2. WIRING DETAILS
Please note, all electrical installations should be carried out by a fully qualified electrician in conformance with
the National Electrical Code and local building codes.
Hot(Black)
Ground
Neutra(White)
3. POWER CONNECTION
Before proceeding to power supply wiring, ensure the electricity supply is turned off at the circuit breaker or
fuse box. Bring the power cable in through the wall.
Insert the ground wire in the grounded connector. Insert the hot and neutral wires into the luminaire
disconnect.
Reconnect power supply and test.
Warranty - This Crosswater London product is covered by a limited lifetime warranty. For full details, terms and conditions
please visit our website.
For further information contact: Crosswater London, 393 Fortune Blvd., Milford, MA 01757 www.crosswaterlondon.com
Toll free number: 844-XWATER-1 (844-992-8371) tel: [phone] fax: [phone]
email: [e-mail]
CLEANING INSTRUCTIONS
The safest cleaner for a mirror is a soft, clean cloth and warm water. If using a glass or mirror cleaner, be sure it does not
contain ammonia or vinegar. Never spray any cleaner directly on to a mirror. Spray the cleaner on to a soft cloth and
then wipe the mirror.
The mirror edges are treated with a specially formulated sealant designed to protect the mirror edges from
contaminants and discoloring.
Care should always be taken to avoid getting the edges and backing of the mirror wet. Should they get wet, dry
immediately.
INSTALLATION
Issue date: 15092019