New England Arbors Cambridge Raised Planter Extension Kit User manual

General Information
•Read Instructions through carefully before beginning assembly.
•When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
•We recommend an area approx 4’x 8’ (1.2 m x 2.4 m) for unobstructed assembling.
•You should not need to use excessive force when assembling components.
Please read through before starting assembly.
Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346 (Mon. to Fri. 8:00 AM to 4:00 PM EST).
(UK Tel: [phone] - Mon. to Fri. 1:00 PM to 10:00 PM GMT).
ASSEMBLY INSTRUCTIONS
The Cambridge Raised Planter Extension Kit
8
1
Not to Scale
1
3
2
Ver 3.3/080817
5
6
4
1. Pre-Assembled Front & Back Wall Panels (2) - 10870
2. Floor Panels (4) - 10871
3. Floor Support (1) - 10872
4. CenterExtension Posts(2)- 10875
5. Pre-assembled Shelf (1) - 10997
6. Post Caps (2) - 10611
7. Centre Support Rail (1) - 10877
8. 5/8”(16 mm) Stainless Steel Screws (20) - 20016
7
12 in
(30 cm)
18 in
(46 cm)
32.5 in
(83 cm)
29 in
(74 cm)
68.5 in
(174 cm)
35.4 in
(90 cm)
32.5 in
(83 cm)
www.newenglandarbors.com
www.newenglandarbors.co.uk

The Cambridge Raised Planter Box Extension
2
O ve r v i ew
This instruction is intended to assist with retrofitting an extension kit to your existing raised planter box.
Some disassembly of the raised planter box will be necessary.
Please look over both sets of instructions for total scope.
The Cambridge Raised Planter Box Extension
Cambridge Raised Planter Box
Extension Kit

The Cambridge Raised Planter Box Extension
4
3
3
2
STE P O N E
Remove the four floor boards.
Place the planter box on its side as shown. Note the shelf rails inside
the posts. The Extension Kit will go on the side which shelf rails are only
inserted half way through the posts.
Remove three screws (2 - 5/8” (16 mm) and 1 - 1 1/2” (38 mm)) from each
of the two posts or a total of six screws as shown. Set aside as these
screws will be re-used later.
Remove two more 5/8” (16 mm) screws from each of the two posts
joining the shelf rails as shown. Set these screws aside as well.
Remove the panel completely as shown and set aside.
Disassemble the Cambridge Raised Planter Box
1
The Cambridge Raised Planter Box Extension
1
2
Shelf Rail bottomed out Shelf Rail half way
into the post
Side to be removed
3
4
5
5

The Cambridge Raised Planter Box Extension
2
4
1
STEP T WO
Lay the side panel extractedfrom Step One from the previous page
on the floor as shown and insertthe pre-assembled shelf into the
routed hole. Repeat for the Front and Back Wall Panels as shown.
Insert the centre support rail into the routed hole on the centre
posts. Push until the tabs lock into place. Note orientation of posts.
Align and insert the two centre posts as shown.
insert the Floor Support Rail into the front and rear walls as shown.
Note the notch at the ends of the floor support rail.
Assemblethe Extension Kit
3
The Cambridge Raised Planter Box Extension
1
Note: Floor Supports location
Note:
The difference
in lengths.
3
4
4
2

The Cambridge Raised Planter Box Extension
5
7
STEP T WO (CONT’D)
Fasten the wall panel into place using the screws set aside from
Step One as shown.
Fasten the Center Posts into place using theprovided
5/8” (16 mm) screws (five per post).
5
The Cambridge Raised Planter Box Extension
6
Center & fasten the Shelf Railsonto the Wall Panel using the
screws set aside from StepOne as shown.
7
5/8” (16 mm) Screws
5
6
5/8” (16 mm) Screws
1 1/2” (38 mm) Screws
5/8” (16 mm) Screws
8
Assemble the extension kit as shown below.

The Cambridge Raised Planter Box Extension
6
2
STE P T H REE
Fasten the extension kit onto the center posts using the 5/8” (16 mm) screws provided (10 total) into the
pre-drilled holes on the center posts.
Attach the Extension Kit
1
The Cambridge Raised Planter Box Extension
5/8” (16 mm) Screws
5/8” (16 mm) Screws
5/8” (16 mm)
Screws
Place the eight floor panels onto the floor supports as shown. Note the notches on the one side of the end panels.
Notch
Notch

The Cambridge Raised Planter Box Extension
Pressure fit the Post Caps into place. Push firmly until they snapinto place.
3
7
STEP T HRE E (CONT’D)
North America Toll Free Phone: [phone]
United Kingdom Tel: [phone]
www.newenglandarbors.com
www.newenglandarbors.co.uk