Crux SOCGM-18L User manual

Crux Interfacing Solutions • 6860 Canby Ave., Suite 116, Reseda, CA 91335
phone: [phone] • fax: [phone] • www.cruxinterfacing.com
rev.051718
SOCGM-18L
Radio Replacement Interface for
GM LAN v2 (LIN) Bus Vehicles
1 of 2
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
- Retains factory features in select GM LAN V2 (LIN) Bus vehicles while functioning with an aftermarket radio.
- Supports non-amplied Systems only.
- Retains chime functions.
- Retains RAP (Retained Accessory Power).
PRODUCT FEATURES:
PARTS INCLUDED:
SOCGM-18L Module SOCGM-18L Harness Antenna Adapter
INSTALLATION DIAGRAM:
AFTERMARKET
RADIO
Reverse Red/White












TO FACTORY
HARNESS
16-Pin Black
Connector
16-Pin Green
Connector
20-Pin Gray
Connector
INTERFACING SOLUTIONS

Crux Interfacing Solutions • 6860 Canby Ave., Suite 116, Reseda, CA 91335
phone: [phone] • fax: [phone] • www.cruxinterfacing.com
rev.051718
SOCGM-18L
Radio Replacement Interface for
GM LAN v2 (LIN) Bus Vehicles
2 of 2
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
INSTALLATION INSTRUCTIONS:
1. Connect the aermarket radio’s
power/speaker harness to the SOCGM-
18L T-Harness using the Installaon
Diagram on page 1. Use good quality
crimp caps or bu splice for a
secure connecon. Solder and heat
shrinking the connecons is highly
recommended.
2. Carefully remove the radio trim with a plasc
pry tool and pull outward.
3. Remove the radio bezel by removing the
4 screws on the corners.
4. Unplug the GREEN and GRAY
connectors from the headunit.
5. Plug the GREEN and GRAY connectors to the
SOCGM-18L T-Harness.
6. Use the supplied antenna adapter to plug
between the OE antenna connector and
aermarket radio antenna port.
7. Use a dash kit (not included) for a clean install. Test the radio for funconality. Test the chime and Retained Accessory Power (RAP)
funcons. Reverse the process to install the new aermarket radio.
VEHICLE APPLICATIONS:
CHEVROLET
2016 – 2017
2015
2016 – 2017
2014 – 2017
2016 – 2017
2014 – 2017
2015 – 2017
2015 – 2017
2017
Camaro
Colorado
Cruze
Impala
Malibu
Silverado
Suburban
Tahoe
Trax
GMC
2017
2015 – 2017
2014 – 2017
2015 - 2017
Acadia
Canyon
Sierra
Yukon