CTA ADD-PARAF1V User manual

VESA Compatible
Graphic Floor Stand Workstation
ADD-PARAF1V
INSTRUCTION - MANUAL
888-733-4448
CONTENTS: 1. INSTALLING BASE:
1A. ALIGN BASE PLATE (A) WITH THE BODY (J) AND
ROTATE IN SCREW (H) FROM THE BOTTOM USING
THE PROVIDED ALLEN KEY TOOL (E).
2. SETTING UP GRAPHIC CARD SLOT
2A. SLIDE OUT THE (2) GRAPHIC CARD PANELS IN THE FRONT AND BACK OF THE BODY (J). IF THERE IS A STICKER FILM, REMOVE
THAT FIRST. IF YOU HAVE PRINTED OUT A STICKER GRAPHIC, PLACE IT ONTO THE PANEL. IF YOU ARE USING A COMPLETE NEW
PANEL, YOU CAN REPLACE THE INITIAL PANELS THAT CAME WITH THE FLOOR STAND. PLACE ONE PANEL BACK FIRST, THEN THE
OTHER.
A
x1 x1
x1 x1
x1
x4 x4
x8
x8
x1
B
CD
E
FG
HI
J
M5 x 12 M5 Hex Nuts
M6 x 18 M5 x 10
J
H

3. SETTING UP CABLE ROUTING
3A. WITH ONLY (1) PANEL BACK IN, SLIDE IN THE POWER CORDS AND ANY OTHER CORDS THAT WOULD NEED TO BE CONNECTED TO THE TABLET
THROUGH THE BODY AS SHOWN. THERE WILL BE GAPS AT THE TOP AND BOTTOM FOR THEM TO ROUTE OUT TO THE POWER SOURCE AND TO THE DEVICE.
SLIDE IN SECOND PANEL WHEN ROUTING IS FINISHED.
888-733-4448
4. INSTALLING THE TRAY, GOOSENECK & VESA
4A. USING THE SMALL
FLAT HEAD SCREWS (E),
ROTATE IN THE SCREWS
TO THE VESA (D) WITH
THE PROVIDED TOOL (E)
UNTIL SECURELY
FASTENED.
4B, ROTATE IN THE
ATTACHED GOOSENECK
WITH THE VESA (D+C) TO
THE TRAY TABLE (B) AS
SHOWN WITH THE
SMALLER FLAT HEAD
SCREWS (I) WITH
PROVIDED TOOL (E)
4C. BEFORE ATTACHING TRAY TABLE COMPONENT, TAKE THE
CABLE THAT’S ALREADY BEEN FISHED THROUGH KIOSK BODY
AND FISH IT THROUGH THE GOOSENECK AND OUT THE VESA
HOLE AS ILLUSTRATED ABOVE.
ALIGN THE TRAY HOLES TO THE KIOSK TOP, ROTATE IN SCREWS
(H) INTO THE TRAY THEN INTO THE STAND WITH PROVIDED TOOL
(E) UNTIL SECURE FASTENED.
D
I
E
C
I
B
E
E
H