CTC Union CT101 Series User manual

Wiring instructions
CT101 SerieS TerminaTion BoxCT101 SerieS TerminaTion Box
1. Strip outer jacket of cable back 1¼ in. and remove all of the shielding.
2. Separate the internal wires from the shield and twist the shield drain wire.
3. Strip red and black insulation back ¼ in.
4. While viewing the rear of the panel, locate the appropriate channel. Using a mini
flathead screwriver, loosen the three screws for the channel and insert the wires
into the termination block.
Orientation is as follows:
a. Red insulated conductor wire is connected to (+).
b. Black insulated conductor wire is connected to (-).
c. Shield drain wire is connected to ground (GND).
d. Tighten the screw on each wire to hold it in place.
(-)
Shield / Drain wire
(+)
1¼”
¼”
Visit our website to download the
full manual for CT101 enclosures.

Wiring instructions
CT101 SerieS TerminaTion BoxCT101 SerieS TerminaTion Box
Mw-CT101-4/Rev A
E
NSIONS
E
SHEET
Sensor Inputs
Red = Positive
Black = Common
Grey = Shield (Ground)
SENSOR #1 SENSOR #2 SENSOR #3 SENSOR #4
E
NSIONS
E
SHEET
Sensor Inputs
Red = Positive
Black = Common
Grey = Shield (Ground)
SENSOR #1 SENSOR #2 SENSOR #3 SENSOR #4
Inputs