CTEK BATTERY ANALYZER User manual

EN • 3
+
+
–
–
TEST
DOWN
UP
BATTERYANALYZER
+
+
–
–
TEST
DOWN
UP
BATTERY ANALYZER
1
2
3
4
5
CONGRATULATIONS
On the purchase of your new professional CTEK Battery Analyzer. The Battery Analyzer
represents the latest technology in battery testing and will provide you quickly and safely
with easy to understand, accurate results.
1. Connect the red clamp to the positive (+) terminal and the black clamp to the negative (-)
terminal. The Battery Analyzer switches on when both connections are made.
2. Ensure a good connection by moving the clamps around on the terminals. The Battery
Analyzer requires that both sides of each clamp be properly connected before testing
can take place. A poor connection will result in the ‘CHECK CONNECTION’ warning.
If this happens, clean the battery terminals and clamps and reconnect.
3. Following the start up screens, enter the rating of the battery you are testing* (EN or
CCA according to Battery Analyzer model) using the ‘▲’ and ‘▼’ buttons. The default
setting is 500 EN (or 500 CCA according to model).
4. Press the TEST button and begin the battery test.
5. The result of the test is displayed on the screen.
6. If retest is required, disconnect the Battery Analyzer, reconnect it to the battery ter-
minals, and repeat the process.
CONNECTING THE ANALYZER TO THE BATTERY
Note: Tests should only be undertaken with the vehicle engine and any electrical loads in
the ‘Off’ position.
IDENTIFYING YOUR BATTERY RATING
Your battery should have a label attached showing its performance rating. Use this infor-
mation to set the Battery Analyzer. If not visible contact your battery supplier for guidance.
Battery label
- typical location
MANUAL

4 • EN
20018478C
BATTERY RATING COMPARISON TABLE
Use this table to compare your reading with other popular battery standards. See battery
label for details or contact your battery supplier for guidance.
BATTERY TEST RESULTS
BATTERY GOOD
Return the battery to service. No action required.
GOOD / RECHARGE
Fully charge the battery and return to service.
CHARGE & RETEST
Fully charge the battery and retest.
(Fully charge the battery before retesting to ensure accurate readings).
REPLACE BATTERY
Test results indicate that the battery is failing and should be replaced.
SPECIFICATIONS
BATTERY VOLTAGE MEASUREMENTS
(Operating Voltage Range: 8.0 V to 15.0 V)
Minimum (V) Maximum (V) Resolution (V) Accuracy (V)
815 0.1 ±0.1
MEASUREMENTS
Model Range Resolution Accuracy
EN 200–1200 EN 25 ±25
US 200–1200 CCA 25 ±25
SAE/CCA EN EN2 IEC DIN
200 180 175 130 110
250 230 220 160 140
300 280 265 195 170
350 330 310 225 200
400 360 350 260 225
450 420 400 290 255
500 480 440 325 280
550 520 485 355 310
600 540 530 390 335
650 600 570 420 365
700 640 615 450 395
750 680 660 485 420
800 760 705 515 450
850 790 750 550 480
900 860 790 580 505
950 900 835 615 535
1000 940 880 645 560
1050 1000 925 680 590
110 0 1040 970 710 620
115 0 1080 1010 745 645
1200 115 0 1055 775 675

EN • 5
20018478C
LIMITED WARRANTY
CTEK SWEDEN AB issues this warranty to the original purchaser of this product. This lim-
ited warranty is not transferable. The warranty applies to manufacturing faults and material
defects for 2 years from the date of purchase. The customer must return the product together
with the receipt of purchase to the point of purchase. This warranty is void if the Analyzer
has been opened, handled carelessly or repaired by anyone other than CTEK Sweden AB
or its authorised representatives. CTEK Sweden AB makes no warranty other than this limited
warranty and is not liable for any other costs other than those mentioned above, i.e. no
consequential damages. Moreover, CTEK Sweden AB is not obligated to any other warranty
other than this warranty.
SUPPORT
CTEK offers a professional customer support: www.ctek.com.
For latest revised user manual see www.ctek.com.
SAFETY
Checkthe batteryfor any signsof damage. Ifnot a maintenance free battery, andthe electrolyte
level is low, top it up and fully charge the battery. Always take suitable safety precautions when
working with batteries to avoid serious injury or death.
MAINTENANCE INSTRUCTIONS
The CTEK Battery Analyzer is maintenance-free. The unit must not be opened; doing so will
invalidate the warranty. The casing can be cleaned using a damp cloth and mild cleaning
agent.

ENGLISH CTEK SAFETY INSTRUCTION
• Thechargerisdesignedforchargingonlybatteriesaccordingtothetechnicalspecication.Donot
usethechargerforanyotherpurpose.
• Alwaysfollowbatterymanufacturers’userandsafetyrecommendations.
• Nevertrytochargenon-rechargeablebatteries.
• Neverplacethechargerontopofthebatteryorcoverthechargerwhencharging.
• Neverchargeafrozenordamagedbattery.
• Neveruseachargerwithdamagedcables.Ensurethatthecableshavenotbeendamagedbyhot
surfaces,sharpedgesorinanyotherway.
• Neverplaceafan-cooledchargersothatdust,dirtorsimilarcanbesuckedintothefan.
• AdamagedcablemustbereplacedbyaCTEKrepresentativeusinganoriginalpartsuppliedby
CTEK.AdetachablecablecanbereplacedbytheuserusinganoriginalpartsuppliedbyCTEK.
• Neverextendthechargecabletoatotallengthofmorethan5.0m.Useonlyoriginalpartssupplied
byCTEK.
• Connectiontothemainssupplymustbeinaccordancewiththenationalregulationsforelectrical
installations.
• Chargerswithgroundedmainsplugmustonlybeconnectedtoagroundedsocketoutlet.
• Duringcharging,Lead-Acidbatteriescouldemitexplosivegases.Preventsparksclosetothebattery.
Provideforgoodventilation.
• ChargerswithIP-classlowerthanIPX4aredesignedforindooruse.Seetechnicalspecication.Donot
exposetorainorsnow.
• Connectthechargertothebattery´spositivepoleandthentothenegativepole.Forbatteriesmount-
edinsideavehicle,connectthenegativeconnectiontothevehiclechassisremotefromthefuelpipe.
Thenconnectthechargertomainssupply.
• Disconnectthechargerfromthemainssupply.Nextremovethenegativeconnection(vehiclechassis)
andthenthepositiveconnection.
• Don’tleaveanybatteryunattendedforalongerperiodoftimeduringcharging.Ifanyerroroccurs
disconnectthechargermanually.
• (IEC7.12ed.5)Thisapplianceisnotintendedforusebypersons(includingchildren)withreduced
physical,sensoryormentalcapabilities,orlackofexperienceandknowledge,unlesstheyhavebeen
givensupervisionorinstructionconcerninguseoftheappliancebyapersonresponsiblefortheirsafe-
ty.Childrenshouldbesupervisedtoensurethattheydonotplaywiththeappliance.
(EN7.12)Thisappliancecanbeusedbychildrenagedfrom8yearsandaboveandpersonswith
reducedphysical,sensoryormentalcapabilities,orlackofexperienceandknowledgeiftheyhave
beengivensupervisionorinstructionconcerninguseoftheapplianceinasafewayandunderstand
thehazardsinvolved.Childrenshallnotplaywiththeappliance.Cleaningandusermaintenanceshall
notbemadebychildrenwithoutsupervision.
20021017C