CUBETAPE C190POS User manual

Quick Start Guide for C190SHP,
C190POS, C190DSK – Page 1
C190SHP, C190 POS, C190 DSK User Guide Page 1
Cubetape
C190 POS
C190DSK
Cradle
C190CRC
USB Cable
www.cubetape.com
Quickstart
Guide
Contents of C190SHP:
• Aer cradle installaon, power on Cubetape
(hold the “m” buon down for 2 seconds).
• Scan the Bluetooth pairing barcode on the front of the cradle.
• Cubetape is successfully connected to the cradle, when the Blue LED
indicators on Cubetape and the cradle are permanently ON.
• If the Blue LED indicators connue to ash,
re-scan the Bluetooth pairing barcode on the cradle.
Bluetooth Pairing: to pair Cubetape with its cradle
Pairing
barcode
Operaons and Measuring:
√
CORRECT
INCORRECT
x
Extend the tape, press the
‘m’ buon
to scan the barcode
measurement on the tape
• Blue LED indicators are on permanently when connected
• To scan a barcode ID, press ‘m’
• Blue LED ON when connected to host
DIP switches beneath cradle:
USB
Cable
PC
Cradle
Installaon:
OFF ON DEFAULT
BT MODE
COMMS MODE
RESERVED
RESERVED
MASTER
USB-VPC
--
--
SLAVE
USB-HID
--
--
ON
ON
OFF
OFF

Quick Start Guide for C190SHP,
C190POS, C190DSK – Page 2
www.cubetape.com
Baery Tape
Cassee
Tape
Compartment
C190POS General Sengs
Sux TAB (Default)
Sux CR
O oor or Inside Measure ON
{G2043/1/ }
Bluetooth Cradle Mode (Default)
Bluetooth SPP Mode
Bluetooth HID Mode
Bluetooth Reset
00000058
00000008
00000038
00000007
www.cubetape.com/documents/C190POS-user guide
C190SHP, C190 POS, C190 DSK User Guide Page 2
Place device in the cradle
Low baery warning will signal with long
beep and green LED on cubetape will be
solid when charging
Charging:
Device LED
RED - CUBETAPE charging
GREEN - CUBETAPE charged
Baery
Compartment