
18
the user manual . Keep children away from the
installation site . After unpacking the appliance, make
sure that it has not been damaged during transport .
In the event of problems, contact the dealer or your
nearest After-sales Service . Once installed, packaging
waste (plastic, styrofoam parts etc .) must be stored
out of reach of children - risk of suffocation . The
appliance must be disconnected from the power
supply before any installation operation - risk of
electric shock . During installation, make sure the
appliance does not damage the power cable- risk of
fire or electric shock . Only activate the appliance
when the installation has been completed .
Carry out all cabinet cutting operations before
fitting the appliance and remove all wood chips and
sawdust .
Do not obstruct the minimum gap between the
worktop and the upper edge of the oven- risk of
burns .
Do not remove the oven from its polystyrene foam
base until the time of installation .
After installation, the bottom of the appliance
must no longer be accessible- risk of burns .
Do not install the appliance behind a decorative
door- risk of fire .
If the appliance is installed under the worktop, do
not obstruct the minimum gap between the
worktop and the upper edge of the oven - risk of
burns .
This appliance is intended to be used built-in . Do
not use it freestanding or place into a cabinet .
After unpacking the appliance, make sure that the
appliance door closes properly .
In the event of problems, contact the dealer or your
nearest After-sales Service .
ELECTRICAL WARNINGS
The rating plate is on the front edge of the oven
(visible when the door is open) .
It must be possible to disconnect the appliance
from the power supply by unplugging it if plug is
accessible, or by a multi-pole switch installed
upstream of the socket in accordance with the
wiring rules and the appliance must be earthed in
conformity with national electrical safety standards .
Do not use extension leads, multiple sockets or
adapters . The electrical components must not be
accessible to the user after installation . Do not use
the appliance when you are wet or barefoot . Do not
operate this appliance if it has a damaged power
cable or plug, if it is not working properly, or if it has
been damaged or dropped .
If the supply cord is damaged, it must be replaced
with an identical one by the manufacturer, its service
agent or similarly qualified persons in order to avoid
a hazard- risk of electric shock .
In case of replacement of power cable, contact an
authorised service centre .
CLEANING AND MAINTENANCE
WARNING: It is hazardous for anyone other than a
competent person to carry out any service or repair
operation that involves the removal of a cover which
give protection against exposure to microwave
energy .
. Failure to maintain the oven in a clean condition
could lead to deterioration of the surface that could
adversely affect the life of the appliance and possibly
result in a hazardous situation .
The oven must be cleaned regularly and any food
deposits removed
WARNING: Ensure that the appliance is switched
off and disconnected from the power supply before
performing any maintenance operation . To avoid
risk of personal injury use protective gloves (risk of
laceration) and safety shoes (risk of contusion); be
sure to handle by two persons (reduce load); never
use steam cleaning equipment (risk of electric
shock) . Non-professional repairs not authorised by
the manufacturer could result in a risk to health and
safety, for which the manufacturer cannot be held
liable . Any defect or damage caused from non-
professional repairs or maintenance will not be
covered by the guarantee, the terms of which are
outlined in the document delivered with the unit .
Regularly clean appliance door internal side and
related gasket, without removing it . Use a soft
sponge, mild water and neutral soap; dry using a
neutral soft cloth . Do not use metal scrapers .
Do not use harsh abrasive cleaners or metal
scrapers to clean the door glass since they can
scratch the surface, which may result in shattering of
the glass .
Ensure the appliance is cooled down before any
cleaning or maintenance- risk of burns .
DISPOSAL OF PACKAGING MATERIALS
The packaging material is 100% recyclable and is marked with the
recycle symbol .
The various parts of the packaging must therefore be disposed of
responsibly and in full compliance with local authority regulations
governing waste disposal .
DISPOSAL OF HOUSEHOLD APPLIANCES
This appliance is manufactured with recyclable or reusable materials .
Dispose of it in accordance with local waste disposal regulations .
For further information on the treatment, recovery and recycling of
household electrical appliances, contact your local authority, the
collection service for household waste or the store where you purchased
the appliance . This appliance is marked in compliance with European
Directive 2012/19/EU, Waste Electrical and Electronic Equipment (WEEE) .
By ensuring this product is disposed of correctly, you will help prevent
negative consequences for the environment and human health .
The symbol on the product or on the accompanying documentation
indicates that it should not be treated as domestic waste but must be
taken to an appropriate collection centre for the recycling of electrical
and electronic equipment .
DECLARATIONS OF CONFORMITY
This appliance is in compliance with the European standard EN 60705 .
This product contains a light source of energy efficiency class G .