Cypress EZ-BT CYBT-483039-PROG User manual

EZ-BTTM MODULE PROGRAMMING KIT
CYBT-483039-PROG
The EZ-BTTM Module Programming Kit (CYBT-483039-PROG)
enables you to easily program the CYBT-483039-02 EZ-BTTM
WICED module.
The life time of the socket used in this programming kit is
50,000 insertions.
For more information, visit:
www.cypress.com/products/ez-ble-and-ez-bt-bluetooth-modules - EZ-BT Module home page
http://www.cypress.com/WICEDModuleProgrammerUserGuide - WICED Module Programmer
User Guide – KBA225060
www.cypress.com/EZ-Serial - EZ-Serial Firmware Platform page
www.cypress.com/WICED - WICED SDK page
Figure 1: CYBT-483039-PROG Top View
BT Module
P5LP PROG Header
USB Connector

© 2019 Cypress Semiconductor Corporation. All rights
reserved. All trademarks or registered trademarks referenced herein
are the properties of their respective owners. 002-28707 Rev.**
EZ-BTTM MODULE PROGRAMMING KIT
CYBT-483039-PROG
Visit www.cypress.com/support for technical support.
Figure 2: Module in the Socket
To use the CYBT-483039-PROG:
1. Insert the BLE module in the socket (ensure that the BLE module is in the correct position of
the socket, as shown below).
2. Connect the programming device with a USB cable to a computer that has been installed
with WICED Module Programmer (www.cypress.com/WICEDModuleProgrammer).
3. Run the programming software to program the target BLE module with your selected
rmware.