D-Link DCS-5020L Manual

Technical Support Setup Procedure
Page | 1
How to: Change the SSID and Enable to WEP Encryption.
Step 1: Connect the power of the camera and connect LAN cable from the camera to your
router.
Step 2: Run the CD that come with the camera on your computer.
Step 3: Click on next
Step 4: Put a tick in the box beside ‘I accept these terms and conditions.’ Click on Next

Technical Support Setup Procedure
Page | 2
Step 5: Click on Next
Step 6: Click on Next

Technical Support Setup Procedure
Page | 3
Step 7: Click on Next
Step 8: Click on Next
Step 9: Click on Yes.

Technical Support Setup Procedure
Page | 4
Step 10: Copy down the IP address of the DCS-5020L show in the list.
Step 11: Open Internet Explorer and enter the IP address of the camera that you had copy
down on the URL bar.
Step 12: Enter the camera user name and password that had set during setting up of the
camera. Click on OK.
Step 13: Click on Setup > Wireless setup.

Technical Support Setup Procedure
Page | 5
Step 14: Tick on the Enable Wireless. Click on Site survey.
Step 15: Select the Wi-Fi network name you want to connect to
Step 16: Under Wireless Configuration.
a) Select Shared for Authentication
b) Select WEP for Encryption
c) Select 1 for Default Key
d) Enter the wireless password used on your AP or Wireless Router in Key 1.
e) Click on Save Settings.
--- END ---