Dacor Preference SGM304 Technical manual

PLANNING
GUIDE
Web: http://www.Dacor.com
Corporate Phone: [phone]
Specifications are subject to change without notice.
See installation instructions for additional details. 4.9
SGM304, SGM365, SGM466
30”, 36”, 46” Wide,
Preference™ Gas Cooktops
1/2
30"
(762mm)
21"
(533mm)
4" (102mm)
Chassis height
1/4" (6mm) Min.
to combustibles
below chassis
27 1/2"
(699mm)
19 7/8" (505mm)
3 1/8"
(79mm)
7 1/2" (191mm) Min.
to combustible
side wall above
the cooktop
(both sides)
2 1/4"
(57mm) Min.
Vertical
combustible
surface
Rear
wall
2"
(51mm) Min.
25" (635mm)
Minimum Cutout Dimensions for
Model SGM304
36"
(914mm)
21"
(533mm)
19 7/8"
(505mm)
33 3/4"
(857mm)
4" (102mm)
Chassis height
3 1/8"
(79mm)
1/4" (6mm) Min.
to combustibles
below chassis
7 1/2" (191mm) Min.
to combustible
side wall above
the cooktop
(both sides)
2 1/4"
(57mm) Min.
Vertical
combustible
surface
Rear
wall
2"
(51mm) Min.
25" (635mm)
Minimum Cutout Dimensions for
Model SGM365
21"
(533mm)
4" (102mm)
46"
(1168mm)
44 1/2"
(1130mm)
19 7/8" (505mm)
3 1/8"
(79mm)
1/4" (6mm) Min.
to combustibles
below chassis
7 1/2" (191mm) Min.
to combustible
side wall above
the cooktop
(both sides)
Vertical
combustible
surface
Rear
wall
2 1/4"
(57mm) Min.
2"
(51mm) Min.
25" (635mm)
Minimum Cutout Dimensions for
Model SGM466
Revised
07/18/08
WARNING
1. Observe all governing codes and ordinances
during planning and installation. Contact
your local building department for further
information.
2.
This appliance must be installed in accordance
with the accompanying installation
instructions.
All tolerances +1/16” -0 (+1.6 mm, 0) unless otherwise noted.

PLANNING
GUIDE
Web: http://www.Dacor.com
Corporate Phone: [phone]
Specifications are subject to change without notice.
See installation instructions for additional details. 4.10
SGM304, SGM365, SGM466
13"
(330mm)
Max.
A
3 1/8" Min.
(79mm)
30"
(762mm)
Min.
Clearances to Combustibles
18"
(457mm)
Min.
Model
“A”
Minimum
“A”
Maximum
SGM304 30” (762mm) 36” (914mm)
SGM365 36” (914mm) 42” (1067mm)
SGM466 48” (1219mm) 54” (1372mm)
Model
“B”
Minimum
SGM304 29” (737mm)
SGM365 35 1/4” (895mm)
SGM466 46” (1168mm)
1/4” (6mm)
Mimimum clearance
to combustible
surfaces
B
Under Cabinet Clearances - Front View
30”, 36”, 46” Wide,
Preference™ Gas Cooktops
2/2
NOTES:
1. Factory installed liquid propane (LP) special
ordered.
2. Cooktop is supplied with a 48” (1219mm) power
cord, with a three prong grounded plug.
3. Utilities are located in the right rear corner of the
cooktop.
4. See the Combination Installation (CI) section if
installing with a downdraft, wall oven, or warming
oven.
Revised
07/18/08
SGM304
SGM365
SGM466
SGM304LP
SGM365LP
SGM466LP
Gas Type Natural Gas LP Gas
Manifold
Pressure 5” Water Column 10” Water Column
Min. Gas Supply
Pressure ** 6” Water Column 11” Water Column
Total Connected
Load
0.25 Amps
(0.03 kW)
0.25 Amps
(0.03 kW)
Circuit
Requirement
120 Vac,
60 Hz, 15 Amp
120 Vac,
60 Hz, 15 Amp
All tolerances +1/16” -0 (+1.6 mm, 0) unless otherwise noted.