Dacor DO130 Technical manual

PLANNING
GUIDE
1.5
Specications subject to change without notice. Phone: [phone]www.dacor.com
DO
Single, Distinctive™
Wall Oven
(A) Overall
Width
(B) Chassis
Width
(C) Overall
Height
(D)* Chassis
Height
(E) Control
Panel
Overlay
29 3/4”
(75.6 cm)
28 3/8”
(72.1 cm)
28 7/16”
(72.4 cm)
27 1/2”
(69.9 cm)
15/16”
(2.4 cm)
* To top of chassis notch behind control panel
(F) Utility
Cutout Width
(G) Utility
Cutout Height
(H) Utility
Cutout Depth
(J) Control
Panel Depth
(K) Notch
Depth
(L) Chassis
Depth
(M) Notch
Height
5”
(12.7 cm)
5 ¼”
(13.3 cm)
6”
(15.2 cm)
1”
(2.5 cm)
1 5/8”
(4.1 cm)
24”
(61.0 cm)
1”
(2.5 cm)
21 1/8”
(53.7 cm)
ELECTRICAL SPECIFICATIONS
Dedicated Circuit
Requirements Total Connected Load
240 Vac 60 Hz., 4-wire,***
30 Amp. 5.3 kW (23 Amp.)
*** Two 120 Vac hot (L1 and L2), one neutral, one ground
The above specifications are for reference only. See the
appliance data plate for exact specifications.
C
J
B
H
G
F
A
Chassis Notch
Side View
Control panel
front Top of
chassis
Top of
chassis
Utility
cutout
¾” Conduit:
60” (152 cm)
long
K
L
M
E
D
Product tolerances: ±1/16” (±1.6 mm) unless otherwise stated
Document # PG01-007 Revised 10/01/11 Page 1/2
WARNING
• Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
• This appliance must be installed in accordance with the
accompanying installation instructions.
MODEL DO130

PLANNING
GUIDE
1.6
Specications subject to change without notice. Phone: [phone]www.dacor.com
Single, Distinctive
Wall Oven
DO
1 1/2”
(3.8 cm)
typical counter
1“ (2.5 cm) Min.
to combustible floor
3/4” (1.9 cm)
support platform
1“ (2.5 cm) Min. to combustibles
Recommended
electrical
location
4” typical toe kick
36”
(91.4 cm) P
R
SINGLE WALL OVEN - INSTALLED UNDER COUNTER
Recommended
electrical
location
Alternate
electrical
location
4” typical toe kick
N
P
R
3/4” (1.9 cm)
support platform
31 1/4” (79.4 cm)
recommended
1” (2.5 cm) Min.
to bottom of
cabinet door
1” (2.5 cm) Min.
to top of
cabinet door
SINGLE WALL OVEN - CUTOUT DIMENSIONS
(N) Minimum
Cabinet
Width
(P) Minimum
Cut Out Width
(R) Minimum
Cutout Height
30”
(76.2 cm)
28 ½”
(72.4 cm)
27 5/8”
(70.2 cm)
Minimum Interior Cabinet Depth: 24” (61.0 cm)
Cabinet/countertop tolerances: +1/16”, -0, (+1.6 mm, -0) unless otherwise stated
Document # PG01-007 Revised 10/01/11 Page 2/2