DAE INSTRUMENT WSC500A User manual

DAE Instrument
User Manual
V 1.0
https://www.daeinstrument.com
WSC500A
Setting Tool

1
Index
I. About WSC500A
A. Hardware Specification--------------------------------------------------------------------------------02
B. Outward Appearance Overview ---------------------------------------------------------------------02
II. Setting Details
A. Connect--------------------------------------------------------------------------------------------------03
B. Read Parameter------------------------------------------------------------------03
C. Air Rate--------------------------------------------------------------------------------------------------03
D. Power---------------------------------------------------------------------------------------------------- 04
E. Channel and Feq----------------------------------------------------------------------------------------04
F. Set Parameters------------------------------------------------------------------------------------------04
G. Reset Parameters-----------------------------------------------------------------------------------04
H. Disconnect-------------------------------------------------------------------------------------------05

2
I-A. Hardware Specification:
WSC500A PRODUCT SPECIFICATION
Dimension
63x95x54 mm
I/O I Interface
RS485
v
USB
v
RF
v
Device
Baud Rate
9600
RF
RF Setup
v
RF Frequencies
902.125 ~ 927.125 MHz
(Default: 915.125 MHz)
RF Air bps
0.3 ~ 62.5 kbps
(Default: 2.4 kbps)
Long Distance Range
5km
Transmit Power
DC Input
DC 12~15V / 12W
I-B. Outward Appearance Overview:
Input Power
DC12~15 V
Micro USB
USB is only used to connect
computer to set device parameters.
Antenna Input
Wireless Communication
TX/RX Indicator
RS485 Port
RS485
TX/RX Indicator
Indicator light:
Red: WSC500A operating mode
Orange: RF Parameter setting mode

3
II-A. Connect & II-B. Read Parameters:
・Please click “Open Connect”button first to activate the setting tool.
・Please click “Read Parameter” button to get the corresponding parameters.
II-C. Air Rate:
・Air Rate: Default Value is 2.4 kbps.
A H B F G
C D E

4
II-D. Power:
・ Power: Default value is 30dBm.
II-E. Channel:
・Channel: The default value is 65. (Range: 52~77)
The value of Feq will change with the channel.
II-F. Set Parameters & II-G. Reset Parameters:
・Please click “Set Parameters” button to save all the changes.
・Users could rectify all the settings by clicking “Reset Parameters” button.

5
II-H. Disconnect:
・Please remember to click “Close Connect” button to finish all the settings.
❑Friendly Notice: Please make sure that the indicator light turn into red after clicking “Close Connect”.

6
https://www.daeinstrument.com
2020 DAE Instrument Corporation. All Rights Reserved.