Daewoo RC-108 User manual

AVCUUM CLEANER
OWNER'S MANUAL
Model No.: RC-108
READ AND SAVE THESE INSTRUCTIONS
■Thank you for purchasing this vacuum cleaner.
■For proper operation, please read this manual carefully before using.

DESCRIPTION AND USING
2
DUST METER
How to check the DUST METER!
Operate the cleaner with MAX power and keep the wide suction
brush apart from the floor.
• If the red indicator of the DUST METER appears,
– Empty or change the dust bag.
– In case the hose is blocked with a large object, remove it.
• When cleaning with the crevice tool or the dusting brush, the
red indicator may appear. In this case, continue cleaning.
Button
WIDE SUCTION BRUSH
• Change the position of the
button according to the
surface to be cleaned.
POWE
• Connect to
as shown o
• To plug or u
plug itself. D
pull on the
Hole
Hook
HOSE HANDLE
Trouble shooting
■ Before Askig for Service, please check each item below first if you have any trouble with your cleaner.
Problem Check Point Measure
Suction power is
weak
The cleaner does not
work
Power cord will not
rewind
• Dust bag
• Pipe or hose
• Power control switch
• Power cord
• Suction power
• When the dust bag is full or blocked
or any of the accessories are
blocked, the over-heating protection
for the motor is activated.
• Power cord
If the dust bag is full of dust, empty it or change it for a new one.
If clogged or blocked, remove obstructing object.
Make sure to set the power control switch to the curtain
position.
Check if power cord is plugged in.
Check if hose is attached firmly into the suction hole.
Switch off and unplug the cleaner and check the dust bag
and accessoires and remove and blockage. The cleaner can
be switched on again after about 20 minutes.
Pull the power cord out a little and press the cord rewind
button.

3
Hose
Holder Hook
WER CORD
ect to the same voltage
own on the rating label.
g or unplug, grasp the
self. Do not hold or
n the cord.
CLEANING THE FILTER
• Open the cover. • Pull the filter out
from the unit while
lifting the gasket.
• After washing the
filter with water, dry
it completely.
• Insert again in the
same position.
Bag Holder
Rubber
Slot
Hole
1
23
EMPTYING THE DUST BAG
• Open the dust cover and push the dust bag holder in the direction
of the arrow and then take out the dust bag.
• Insert the dust bag board into slots and fit the hole of dust bag on
the rubber hose while pushing the bag holder to the arrow.
Then fix the dust bag by releasing the bag holder.
• The dust cover will not close completely when the dust bag is set
wrong.
KEEPING
• Insert the pipe holder into
the groove. • Hang the hose hanger on the hook.

This vacuum cleaner should only be used for normal dry household dust and dirt.
The manufacturer cannot be held responsible for any damage caused by the use or operation fo this
cleaner contrary to these instructions.
If the cleaner is wrongly operated for a purpose other than that for which it is intended, no liability
cna be accepted for any possible damage.
PRECAUTIONS FOR SAFE USE
4
RED MARK
• Do not vacuum areas which contain
moisture or water and flammable items
needles, pins, razor blades, matches,
cigarette-ends, etc., since they may
damage the cleaner or dust bag.
• When rewinding the power cord, hold onto
the plug before pressing the cord rewind
button to prevent whipping.
• Do not pull the power cord out beyond the
red mark.
• Make sure a dust bag and a motor
protection filter are always inserted. • Do not operate the cleaner if ; – the Power cord is damaged.
– the hose shows visible signs of damage.
It must be replaced by the manufacturer or a
service agent or a similarly qualified person in
order to avoid a hazzard.

Rating AC 230V 50Hz
Watts NOM.: 1000W, MAX.: 1100W
Dimensions 353 X 219 X 253 MM (D X H X W)
Weight 4.2 Kg
Cord length 5 m
Specifications