
54
PRECAUTIONS HOW TO ASSEMBLE
TO START OPERATION
䮦##Before using, please make sure the network voltage coincides with the product rated voltage.
䮦
##When in use, do not block or shelter the rear outlet cover to avoid influencing normal air
exhaustion. Otherwise, the motor will be damaged by overheat.
䮦
##If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
Keep the appliance away from stove or any other high temperature objects so as not to
influence its operation by deforming its plastic parts.
Do not bend, extrude or pull by the flexible hose, Stop using the broken or damaged
hose, instead to use the new hose.
When you need to clean your appliance or stop operation, unplug from the power outlet.
When unplugging, be sure to hold the plug, but not pull or carry by the power cord.
When sucking, do not suck up particles as mud, paste ,wall ashes, or sharp articles.
otherwise it may result in obstruction to the dust cup or air filter or damage to the motor.
If sucking up these particles, please immediately clean the dust cup and air flow filter.
When in use, do not suck up suck hair rolls, large paper rolls or plastic bags which may
easily lead to block the suction hole or suction tube or hose. Other wise it may cause
breakdown or deforming of body cover. If any block occur to the suction ,immediately
stop operation by unplugging from the outlet for cleaning.
When cleaning the appliance, wet cloth soaked with water or neutral detergent shall be
used instead of gasoline or banana water. Otherwise it may lead to breakage of
fadedness of the body cover.
Push the two buttons of hose
head, and insert it into unit inlet
until locked
Pull out the power cord
The power cord can be pulled
out as long as it is marked with
yellow color. It is forbidden to
exceed the red mark
If want to pull out the hose
from unit, please press the two
buttons on the hose before pull
out.
Power button
After plugging into electrical
power outlet, press the power
button on the body cover to
control start and stop.
How to use connecting tubes
and curved wand?
When connecting, insert the
bigger end of the connecting
tube into air flow handle and
then swivel it to firm connection.
Regulation of suction power
You can control suction power
by air flow regulator on handle.
Connection of the tubes. Refer
to the above said.
Connection of connecting tube
with floor brush. For connection,
insert the smaller end of
connecting tube into the tube on
the floor brush, and then swivel it
to firm connection.
Regarding the connection of
connecting tubes with crevice
nozzle, refer to the above said.