
1-4
The following pertains to matters that could cause problems or serious, even life-threatening injuries
should the instructions be ignored or incorrectly followed.
WARNING
Caution
-Follow the national and local regulations to
dispose of the product and battery.
-Be sure to turn OFF the auto-wind lever before
setting the dragging power. Failure to do so may
result in your hand getting cut by the line while
you are pulling it manually for setting the
dragging power.
-Do Not touch the heat radiation area of the
motor. It may become hot, resulting in getting
burned.
-When you do not use the product for fishing,
turn off the winding lever and power supply.
Failure to do so may result in unintended
operation of the product, resulting in injury or
other problems.
Remove!
Remove!
Remove
power supply!
-Depending on the conditions of use or storage of
the product, the cord may breakage or be
shorted out, resulting in smoke or fire. Be sure to
follow the "Precautions for Handling Cord",
"Instructions for Maintenance of Cord" and
"Other Precautions for Maintenance". Be sure to
disconnect the power supply before
maintenance of the cord. An old cord may cause
breakage, short-circuit, or trouble. We
recommend to replace the cord every two years
or every 60 times of use, in order to maintain the
performance of the reel.
Handle it properly!
-Before reconnecting the power cable on the
boat, thoroughly wipe away any moisture such
as saltwater from the connecting parts with a dry
cloth. If you connect it wet, it may short-circuit
causing electric shock, smoke, or even fire.
Cautious
handling! Hands off!
Hands off!
-Do not touch or grab the line when it is being
released or wound rapidly. The line may cut your
fingers.
Heat radiating
section of the motor
Stop winding
Lever off