Danby Silhouette DBC031D4BSSPR User manual

s. 01.
OWNER’S MANUAL
LE MANUEL DU
PROPRIÉTAIRE
DBC031D1BSSPR
CAUTION
Read and follow all safety rules
and operating instructions
before first use of this product.
PRÉCAUTION
Veuillez lire attentivement les
consignes de sécurité et les
instructions d’utilisation avant
l’utilisation initiale de ce produit.
Danby Products Limited, Guelph, Ontario Canada N1H 6Z9
Danby Products Inc., Findlay, Ohio USA 45840
V1.05.14
1-844-455-6097

Important Safety Information
Safety Precautions 3
Grounding Instructions 4
Operating Instructions
Features of Your Beverage Center 5
The Controls of Your Beverage Center 6
Setting the Temperature 6
7Beverage storage 7snoitcurtsnIflehS
Installation Instructions
Tools You Will Need 8
Preparing the Enclosure 8
Care and Cleaning
Helpfull Hints 10
How to Clean the Inside 10
How to Clean the Outside 10
Trouble Shooting
Before Your Call For Service 11
3
5
10
11
1
8
Door Swing Reversal 9
Warranty
11
1
12
TABLE OF CONTENTS
Function Instruction 6

2
WELCOME
NEED HELP?
Welcome to the
Danby family. We’re
proud of our quality
products and we
believe in dependable
service.
You’ll see it in this
easy-to-use manual
and you’ll hear it in the
friendly voices of our
consumer service
department.
Tel:[phone]
Best of all, you’ll
experience these
values each time you
use your beverage
center. That’s impor-
tant, because your
new appliance will be
Before you call for service,
there are a few things you
can do to help us serve
you better...
Read this manual
It contains instructions to
help you use and maintain
your appliance properly.
If you received a
damaged appliance
immediately contact the
dealer (or builder) that sold
you the beverage center.
Save time and money
Check the TroubleShooting
section before calling. This
section helps you solve
common problems thatmay
occur.
If you do need service, you
can relax knowing help is
only a phone call away.
Toll Free: 1-844-455-6097
Write down the model and serial
numbers here. They are on a label
Model number DBC031D1BSSPR
Serial number
Date purchased
Staple your receipt to the inside
back cover of this manual. You will
need it to obtain service under
warranty.
Start Here!…Before using your beverage center
part of your family many
years to come.
located on the back of the unit.

READ ALL SAFETY INFORMATION BEFORE USING
3
IMPORTANT SAFETY INFORMATION
WARNING
SAFETY
PRECAUTIONS
•This appliance must be
grounded. Connect only to a
properly grounded outlet.
See “Grounding Instructions”
section on page 4.
•Do not operate this appliance
if it has a damaged power cord
or plug, if it is not working
properly, or if the appliance has
been damaged or dropped.
•Do not splice the power cord
that is equipped with this appli-
ance.
•Keep power cord away from
heated surfaces.
•Do not immerse power cord,
plug or the appliance itself in
water.
•Do not use this product near
water-for example, in a wet
basement, near a swimming
pool or near a sink.
•Do not use corrosive
chemicals or vapors in this
appliance.
•Use this appliance only for
it’s intended use, as described
in this manual.
•Do not store perishable food
items such as (but not limited
to) meats and dairy products
in your Beverage Center.
•Store beverages in sealed
containers only.
•See door surface cleaning
instructions in the Care and
Cleaning section(s) of this
manual.
•Do not cover or block any
openings on the appliance.
•This appliance is intended for
household use only. Do not
attempt to operate or store this
appliance outdoors.
•This appliance should be
serviced only by qualified serv-
ice personnel. Contact nearest
authorized service facility for
examination, repair or adjust-
ment.
SAVE THESE INSTRUCTIONS
DANGER, RISK OF CHILD ENTRAPMENT!
An empty Beverage center is a very dangerous attraction to children. Remove either the gasket,
latches, lids, lock and/or doors from unused or discarded appliances, or take some other action
to guarantee it harmless.
DON’T WAIT, DO IT NOW!
To reduce the risk of fire, burns, electric shock, or injury to persons when using your appliance,
follow basic precautions, including the following sections;

4
This appliance must be
grounded. In the event of an
electrical short circuit, ground-
ing reduces the risk of electric
shock by providing an escape
wire for the electric current.
This appliance is equipped
with a power cord having a
grounding wire with a ground-
ing plug. The plug must be
plugged into an outlet that is
properly installed and ground-
ed.
Consult a qualified electrician
or service technician if the
grounding instructions are not
completely understood, or if
doubt exists as to whether the
appliance is properly ground-
ed.
If the outlet is a standard 2-
prong wall outlet, it is your per-
sonal responsibility and obliga-
tion to have it replaced with a
properly grounded 3-prong
wall outlet.
For best operation, plug this
appliance into its own electri-
cal outlet to prevent flickering
of lights, blowing of fuse or
tripping of circuit breaker.
Do not under any circum-
stances cut or remove the
third (ground) prong from the
power cord.
Do not use an adapter plug
with this appliance.
Do not use an extension
cord with this appliance. If the
power cord is too short, have
a qualified electrician or serv-
ice technician install an outlet
near the appliance.
GROUNDING
INSTRUCTIONS
IMPORTANT SAFETY INFORMATION
Improper use of the
grounding plug can result
in a risk of electric shock.
Extreme Weight Hazard
Use two or more people when
moving the beverage center.
WARNING!
Beneath the beverage center
there are two leveling legs that
are located on either side of
the vent. It is important that
your beverage center is level.
To level the beverage center:
1. Move the beverage center
to its final location.
2. Have someone gently lean
against the front of the
beverage center to take some
of the weight off of the leveling
legs.
3. Turn the leveling legs clockwise
to raise the beverage center
or counter-clockwise
to lower it. Continue in this
manner until the beverage center
is level. See Fig. A.
Leveling
Instructions
WARNING! Fig A
Raises
the Leg
(lowers
the unit) Lowers
the Leg (raises
the unit)

7
5
Operating Instructions
Features of your
Beverage Center
1. Tempered Glass Door:
Low-E glass - used to reflect and
absorb heat.
2. Electronic Display and Controls:
For viewing and regulating the temperature
of the beverage center.
3. Magnetic Door Gaskets: Tight fitting
seals retain all the cooling power and humid-
ity levels.
5. Vertical Towel Bar Handle
6. Front Mounted Exhaust: Allows for
integrated (built-in) applications.
7. Leveling Legs
8. Interior Light (not shown):Cool White -
5
1
3
2
LED lighting illuminates the interior without the
heat of an incandescent bulb.
6
4
4. Glass shelves

6
Operating Instructions
Setting the
Temperature To switch the display
between the Fahrenheit (°F)
and Celsius (°C) scale,
depress the and
control buttons simultaneo-
usly for approximately
five(5) seconds.
The temperature range can
be set as low as 36°F(2°C)
or as high as 64°F (18°C) to
suit your specific storage
requirements. Each depres-
sion of the but-
ton will allow you adjust the
temperature in 1° degree
increments within the afore-
The Controls of your
Beverage Center
1. Indicator light illuminates to signify the
cooling mode is currently in operation.
2. Button
To control this appliance turn ON/OFF
( press and hold this buttons for
approximately 3 seconds).
3. Button
To control the inner light turn ON/OFF.
(If you press this button, the inner
light is not controlled by the reed
swith, and keep lighting.)
4. °C / °F
Adjacent indicator light denotes which
scale of temperature is displayed.
5.
Button
Used to raise (warmer) the temperature
in 1° degree increments.
Button
Used to decrease (cooler) the
temperature in 1° degree decrements.
mentioned range.
°
°
NOTE
When you plug in your
beverage center for the first
time, the temperatures
will automatically be set
to 54°F (12°C) and will be
displayed in the
Fahrenheit scale (°F).
Function
instruction Temperature Memory Function
 Door Ajar Alarm Function
Temperature Alarm Function
NOTE
In the event of a power interruption the Beverager Center can reme-
mber the previous temperature settings, and when the power is
restored the cabinet temperature will go back to the same setting
temperature as before.
If inner temperature is higher than 73°F(23°C), “HI” is shown
in the display panel, and the alarm will sound after one hour.
If inner temperature is lower than 28°F(-2°C), “LO” is shown in the
display panel and the alarm will sound. Refer to the trouble shooting
guide on page 11 for more information.
If the door is not closed completely the alarm will sound after 5 minutes.
Please close the door completely to avoid the loss of cold energy.
once or the door has not been
closed tightly, the unit will display the
after you close the door and
“HI” will disappear.
It is normal that the cabinet
shows “HI” or “LO” from time to time,
If it occurs frequently or lasts for a
long time, you can restart the unit by
unplugging it. If the problem
occurs once again after restart,
If too many bottles are put in at
"HI" signal in the display panel. This
is normal. Please wait 5 minutes
please contact customer service.
C
F
4
5
1
3
2
or

Operating Instructions
Beverage
Storage
7KHPD[LPXPFDSDFLW\RI
WKH'%&'%6635LV
POEHYHUDJHFDQVDQG
POERWWOHV
6WRUHEHYHUDJHVLQVHDOHG
FRQWDLQHUVRQO\
:KHQVWRFNHGDVSHU
LQVWUXFWLRQV
7
In order to achieve the maximum
storage capacity of sixty-six
(66) cans and four (4) bottles,
it will be necessary to position the
cans alternately on the upper three
glass shelves, as shown in (Fig.B)
This will allow for the storage of
twenty-two (22) 350 ml cans
per of shelf in each of the top three
shelves. The bottom can hold an
additional four (4) bottles (Fig.C)
snoitcurtsnIflehS
)LJ%
(Fig.D)
'JLF
To Remove Glass Shelves:
1. Lift the back of the shelf up so the shelf pegs are above the
lower rail.
2. Slide the shelf out of the unit with the pegs on the upper rail.
)LJ&
Do not cover shelves with alum-
inum foil or any other material
that will prevent adequate air
circulation within the cabinet
,03257$17
,03257$17

8
Installation Instructions - Intergrated Application
Preparing the
Enclosure
Tools You Will Need
The appliance must be
connected to an individual
properly grounded electrical
outlet, protected by a 15 or
20
ampere circuit breaker or
time delay fuse.
It is recommended that you do
not install the beverage cooler
into a corner (i.e. directly beside
a wall). This is to allow the
door(s) to have a greater then
90° opening swing. A limited
door swing will prevent the
shelves from sliding out as
intended, and may lead to dam-
aging the door gasket(s).
The electrical outlet may be
positioned from within either
side of the adjacent cabinetry, or
the rear of the shaded area (as
shown in Fig F).
If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1-1/2”(3.81cm) diameter hole to
admit the power cord. If the cabi-
net wall is metal, the hole edge
must be covered with a bushing
or grommet.
Electrical Requirements: Important: If the electrical outlet
is surface mounted (not flush)
within the enclosure, the depth
requirement for the installation
may be affected.
*The listed depth requirement for the
installation is assuming that the electrical
outlet is located in the adjacent cabinetry
or is flush mounted in the rear wall, not
surface mounted in the enclosure.
The rough cabinet opening
must be on a level floor area
and at least 23 1/16” deep
(63.2cm) by 15 1/16”(38.6cm)
wide. The opening should also
have a height of at least
34 9/16”(86.8 cm).
NOTE:
This unit is front breathing.
Do not block the front air vent.
Blockageof the vent will result
in high operating temperatures
and system failure. (Fig.E)
15
1
/ 16 ”
1
1
/ 2 ”dia hole
*If electrical outlet
is in adjacent cabinetry
1
3
/ 16 ”
34 9/ 16”
From underside
of countertop
to floor
6”
231 /16”
min
Cabinet is
square
and plumb
Electrical Access
Fig E
Fig F
Tape measure
Carpenter square
Electric drill with hole bit
Gloves Level
Safety goggles
Flashlight
be
While performing
installations
described in this
section, gloves,
safety glasses
or
goggles should
worn.
FOR YOUR
SAFETY

Installation Instructions - Door Swing Reversal
1 Bottom hinge (Right) 2 Screws 3 Door axis
4 Screws 5 Reed swith 6 Top hinge (Right)
7 Screws 8 Top hinge (Left) 9 Decorative nail
Fig 1A Fig 1B
Fig 1D
9
Fig 1C
1When open the door 90 degree, take out 2 screws from lower door axis (3),
remove the door refer Fig. 1A, then pull out the door and door axis (Fig. 1A).
2Put the door safety,unscrew 2 screws (4) at bottom and remove
the Reed switch (5),then install (5) at top of door frame,
(Fig. 1A/1B)
3Make out 3 screws (7) from top hinge (right) (6) and remove the right top
hinge. (Fig. 1C)
4Remove decorative nail (9) from left top of cabinet and install spare top
hinge (Left) (8) at left top of cabinet with 3 screws. (Fig. 1D)
5According above procedure, install spare lower hinge (left) (10) onto left
lower cabinet. (Fig. 1E)
6The door revolves 180 degrees, install the door with same way it was removed
and fix it with door alightment.
7Block the hole at right top of cabinet with spare decorative nail.
Fig 1E
10 Bottom hinge (Left)
Please note: Do not lay unit on it's back.