Dancover AC153000 User manual

for
Screen/Sidewall for
Gazebo San Pablo
Manual
17-03-2020

INSTALLATION INSTRUCTIONS

Qty
Hinge ring
Screw for hinge ring
M4x25
Nuts for hinge ring M4
Hand crank
1xL
1xR
1xL
1xR
We recommend that the screen (s) are always rolled up
due to weather and wind.
when the pergola is not in use,
Main module(A)
Mounting rail(B)
Insert rail(C)
Plastic profile

1. Assemble the mounting rails and main module
right mounting rail
main frame
left mounting rail
Attach the mounting rails (B) to the end of the main module (A) as on
the sketch below.

2. Lift the main module up and move it into the mounting area
The main module (A) is held up by
the two frame rail (B).
Place the main moudle
where it is to be mounted.

3. Mount on pergola
cross section
pergola
pergola
rail(B)

4. Mount the plastic profile/fabric
Attach the fabric to the frame on both sides.
1. Make sure the
stands straight before
plastic profile.
mounting rails (B)
the fabric into the
2. Insert the plastic profile
into the mounting rail (B)
section of
plastic profile
mounting rail(B)
plastic profile
plastic profile
mounting rail(B)
mounting rail(B)
plastic profile
mounting rail(B)
plastic profile

After the plastic profile is installed, pull down the fabric to adjust it
before installing the insert rails.

6. Mount insert rail
insert rail(C)
mounting rail(B)
insert rail(C)
mounting rail(B)
mounting rail(B)
mounting rail(B)
plastic profile
insert rail(C)
plastic profile
insert rail(C) TIP! Use a rubber hammer to hit
gently from bottom to top, if any
difficult to get the insert rails in place.

7. Mount hinge ring
1. Insert the hinge ring into the gearbox shaft
2. Screw M4x25 with hinge ring 3.Lock with nut M4