DAQ ADP-CLD01 User manual

ADP-CLD01 user’s Manual (Rev(1.0)
-1- http://www.daqsystem.com
Camera Link
Repeater & Distributer
(ADP-CLD01)
User’s Manual
Windows, Windows2000, Windows NT and Windows XP are trademarks of Microsoft. We acknowledge that the
trademarks or service names of all other organizations mentioned in this document as their own property.
Information furnished by DAQ system is believed to be accurate and reliable. However, no responsibility is assumed by DAQ
system for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is
granted by implication or otherwise under any patent or copyrights of DAQ system.
The information in this document is subject to change without notice and no part of this document may be copied or
reproduced without the prior written consent.
Copyrights 2005 DAQ system, All rights reserved.

ADP-CLD01 user’s Manual (Rev(1.0)
-2- http://www.daqsystem.com
-- Contents --
1. Introduction
2. Functions
3. Layout
- 9 ~ 24V DC DIN Connector (SN8-6P)
- 9 ~ 24V Connector (DC-005(2.0))
4. Product Contents

ADP-CLD01 user’s Manual (Rev(1.0)
-3- http://www.daqsystem.com
1. Introduction
Currently, a lot of industrial equipment Digital cameras are used. Frame Grab board and the
direct connection of the camera is limited by the distance of the equipment, apparatus.
ADP-CLD01 gives approximately doubles the maximum transmission distance. Standard
Camera Link specification has been designed to suit fits all cameras in the Camera Link
specification.

ADP-CLD01 user’s Manual (Rev(1.0)
-4- http://www.daqsystem.com
[ADP-CLD01 Features]
Standard Camera Link Specification
Base Camera Link Full Mode
Camera Link Repeater & Distributer
6Pin Locking Type, Power connector
9 ~ 24V/DC Input Voltage (DIN Connector or DC-jack) Power Connector selectable
Maximum Transfer Distance 10M / Bi-direction(20M)

ADP-CLD01 user’s Manual (Rev(1.0)
-5- http://www.daqsystem.com
2. Functions
Distributer Function : J3 -> J1 (Without Camera Control, SerTFG, SerTC)
Repeater Function : J3 -> J2

ADP-CLD01 user’s Manual (Rev(1.0)
-6- http://www.daqsystem.com
Use the connection between the Frame Grabber and camera, as shown in the following
figure.

ADP-CLD01 user’s Manual (Rev(1.0)
-7- http://www.daqsystem.com
3. Layout

ADP-CLD01 user’s Manual (Rev(1.0)
-8- http://www.daqsystem.com
-9 ~ 24V DC DIN Connector (SN8-6P)
Pin No.
Description
Pin1
N.C
Pin2
+24V/DC
Pin3
+24V/DC
Pin4
GND
Pin5
GND
Pin6
GND
-9 ~ 24V Connector (DC-005(2.0))
DC 24V
DC 24V

ADP-CLD01 user’s Manual (Rev(1.0)
-9- http://www.daqsystem.com
4. Product Contents
①ADP-CLD01 Board
②6PIN DIN CONNECTOR (SN8-6P)
③24V-DC Adaptor
④CD (Manual)