Data Video TPC-700 User manual

PoE

2
Table of Contents
TABLE OF CONTENTS ..................................................................................... 2
WARNINGS AND PRECAUTIONS .................................................................... 6
WARRANTY ................................................................................................... 7
STANDARD WARRANTY .......................................................................................7
THREE YEAR WARRANTY......................................................................................8
DISPOSAL ...................................................................................................... 9
CHAPTER 1 INTRODUCTION......................................................................... 10
1.1 FEATURES ..................................................................................................10
CHAPTER 2 SYSTEM DIAGRAM .................................................................... 11
CHAPTER 3 CONNECTIONS .......................................................................... 12
3.1 FRONT VIEW ..............................................................................................12
3.2 REAR VIEW ................................................................................................13
3.3 LEFT VIEW .................................................................................................14
3.4 RIGHT VIEW ...............................................................................................15
CHAPTER 4 HOW TO TURN ON AND TURN OFF THE POWER OF THE TPC-
700/TPC-700P.............................................................................................. 16
CHAPTER 5 TPC-700 & TPC-700P’S SETTINGS OPTION ................................. 17
CHAPTER 6 BASIC SETUP ............................................................................. 24
6.1 CONNECT BY STATIC IP ADDRESS....................................................................24
6.2 CONNECT BY DHCP.....................................................................................24
CHAPTER 7 NETWORK SETTINGS ................................................................. 25
7.1 CONNECT BY STATIC IP ADDRESS....................................................................25
7.2 CONNECT BY DHCP.....................................................................................30
CHAPTER 8 THE 8 PRE-SAVED VIRTUAL SCENES FOR THE SE-3200 & TPC-
700/TPC-700P COMBINATION..................................................................... 33
8.1 THE INPUT INTERFACE SETTINGS FOR THE SE-3200 &TPC-700/TPC-700P
COMBINATION..................................................................................................34

3
8.2 THE 8PRE-SAVED VIRTUAL SCENES FOR THE SE-3200 AND TPC-700/TPC-700P
COMBINATION..................................................................................................37
CHAPTER 9. HOW TO SET THE CHROMAKEY, SAVE A STILL TO MEMORY, P-IN-
P AND STILL FUNCTIONS.............................................................................. 40
CHAPTER 10 INTRODUCTION OF THE SE-3200 APP INTERFACE FOR THE TPC-
700/TPC-700P.............................................................................................. 41
10.1VIRTUAL SCENES .......................................................................................42
10.1.1 HOW TO RECALL THE PRE-SAVED VIRTUAL SCENES BY THE TPC-700/TPC-700P
.....................................................................................................................46
10.2 AUX.......................................................................................................47
10.2.1 HOW TO USE THE “AUX” FUNCTION .........................................................47
10.3 CROSS POINT............................................................................................49
10.3.1 HOW TO USE THE CROSS POINT FUNCTION .................................................49
10.4 FLEX SOURCE............................................................................................52
10.4.1 HOW TO USE THE FLEX SOURCE FUNCTION .................................................53
10.5 PIP.........................................................................................................55
10.6 SETUP .....................................................................................................57
CHAPTER 11. INTRODUCTION OF THE BUILT-IN VGB-2000 APP INTERFACE
FOR THE TPC-700/TPC-700P ........................................................................ 60
11.1 MAIN INTERFACE OF THE TPC-700 APP-SINGLE &DUAL..................................61
11.2 OPERATION STEPS FOR THE VGB-2000 APP FOR TPC-700/TPC-700P .............63
CHAPTER 12 INTERFACE INTRODUCTION OF THE TPC-700/TPC-700P BUILT-IN
DVK-400 APP............................................................................................... 70
12.1 HOME.....................................................................................................70
12.2 INPUT/OUTPUT ........................................................................................72
12.3 CHROMAKEY.............................................................................................73
12.4 LUMAKEY.................................................................................................74
12.5 WINDOW ................................................................................................76
12.6 USER MEMORY .....................................................................................77
12.7 CONNECT.................................................................................................78
12.8 SETUP .....................................................................................................79
CHAPTER 13 INTERFACE INTRODUCTION OF THE TPC-700/TPC-700P BUILT-IN
ZR-1 APP...................................................................................................... 85

4
13.1 CONNECTIONS ..........................................................................................85
13.2 ZR-1 MAIN INTERFACE...............................................................................86
13.2.1 3 cams Interface-Home.................................................................88
13.2.2 2 cams Interface-Home.................................................................93
13.2.3 Connection-for 3 cams & 2 cams Interfaces .................................95
13.2.4 Encoding-for 3 cams & 2 cams Interfaces.....................................97
13.2.5 Camera-for 3 cams & 2 cams Interfaces.....................................107
13.2.6 Switcher-for 3 cams & 2 cams Interfaces ...................................109
13.2.7 Audio-for 3 cams & 2 cams Interfaces........................................116
CHAPTER 14 INTERFACE INTRODUCTION OF THE TPC-700/TPC-700P BUILT-IN
TVS-2000A APP.......................................................................................... 118
14.1 HOME...................................................................................................118
14.2 ADVANCE...............................................................................................126
14.3 STUDIO .................................................................................................128
CHAPTER 15. SOFTWARE UPDATE (APP MANAGE SW) .............................. 130
CHAPTER 16. DIMENSIONS........................................................................ 132
CHAPTER 17. SPECIFICATIONS ................................................................... 133
APPENDIX.................................................................................................. 134
SOFTWARE UPDATE PROCEDURE FOR TPC-700 & TPC-700P...................... 134
1. INTRODUCTION ................................................................................ 134
2. PREPARATION.................................................................................. 134
2.1 SYSTEM REQUIREMENTS ....................................................................134
2.2 SOFTWARE UPDATE PREPARATION................................................................135
2.3 SYSTEM CONNECTION DIAGRAM ..................................................................136
2.4 CHECKING THE SOFTWARE VERSION..............................................................138
2.5 PREPARING THE SOFTWARE.........................................................................142
3. UPDATE ................................................................................................. 142
3.1 UPDATING THE SOFTWARE..........................................................................142
SERVICE AND SUPPORT ............................................................................. 156

5
Disclaimer of Product & Services
The information offered in this instruction manual is intended as a guide only. At all times,
Datavideo Technologies will try to give correct, complete and suitable information. However,
Datavideo Technologies cannot exclude that some information in this manual, from time to time,
may not be correct or may be incomplete. This manual may contain typing errors, omissions or
incorrect information. Datavideo Technologies always recommend that you double check the
information in this document for accuracy before making any purchase decision or using the
product. Datavideo Technologies is not responsible for any omissions or errors, or for any
subsequent loss or damage caused by using the information contained within this manual. Further
advice on the content of this manual or on the product can be obtained by contacting your local
Datavideo Office or dealer.

6
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Warnings and Precautions
1. Read all of these warnings and save them for later reference.
2. Follow all warnings and instructions marked on this unit.
3. Unplug this unit from the wall outlet before cleaning. Do not use liquid or
aerosol cleaners. Use a damp cloth for cleaning.
4. Do not use this unit in or near water.
5. Do not place this unit on an unstable cart, stand, or table. The unit may
fall, causing serious damage.
6. Slots and openings on the cabinet top, back, and bottom are provided for
ventilation. To ensure safe and reliable operation of this unit, and to
protect it from overheating, do not block or cover these openings. Do not
place this unit on a bed, sofa, rug, or similar surface, as the ventilation
openings on the bottom of the cabinet will be blocked. This unit should
never be placed near or over a heat register or radiator. This unit should
not be placed in a built-in installation unless proper ventilation is
provided.
7. This product should only be operated from the type of power source
indicated on the marking label of the AC adapter. If you are not sure of
the type of power available, consult your Datavideo dealer or your local
power company.
8. Do not allow anything to rest on the power cord. Do not locate this unit
where the power cord will be walked on, rolled over, or otherwise
stressed.
9. If an extension cord must be used with this unit, make sure that the total
of the ampere ratings on the products plugged into the extension cord do
not exceed the extension cord rating.
10. Make sure that the total amperes of all the units that are plugged into a
single wall outlet do not exceed 15 amperes.

7
11. Never push objects of any kind into this unit through the cabinet
ventilation slots, as they may touch dangerous voltage points or short out
parts that could result in risk of fire or electric shock. Never spill liquid of
any kind onto or into this unit.
12. Except as specifically explained elsewhere in this manual, do not attempt
to service this product yourself. Opening or removing covers may expose
you to dangerous voltage points or other risks, and will void your
warranty. Refer all service issues to qualified service personnel.
13. Unplug this product from the wall outlet and refer to qualified service
personnel under the following conditions:
a. When the power cord is damaged or frayed;
b. When liquid has spilled into the unit;
c. When the product has been exposed to rain or water;
d. When the product does not operate normally under normal
operating conditions. Adjust only those controls that are covered by
the operating instructions in this manual; improper adjustment of
other controls may result in damage to the unit and may often
require extensive work by a qualified technician to restore the unit to
normal operation;
e. When the product has been dropped or the cabinet has been
damaged;
f. When the product exhibits a distinct change in performance,
indicating a need for service.
Warranty
Standard Warranty
Datavideo equipment are guaranteed against any manufacturing defects
for one year from the date of purchase.
The original purchase invoice or other documentary evidence should be
supplied at the time of any request for repair under warranty.
The product warranty period beings on the purchase date. If the purchase
date is unknown, the product warranty period begins on the thirtieth day
after shipment from a Datavideo office.
All non-Datavideo manufactured products (product without Datavideo
logo) have only one year warranty from the date of purchase.

8
Damage caused by accident, misuse, unauthorized repairs, sand, grit or
water is not covered under warranty.
Viruses and malware infections on the computer systems are not covered
under warranty.
Any errors that are caused by unauthorized third-party software
installations, which are not required by our computer systems, are not
covered under warranty.
All mail or transportation costs including insurance are at the expense of
the owner.
All other claims of any nature are not covered.
All accessories including headphones, cables, and batteries are not
covered under warranty.
Warranty only valid in the country or region of purchase.
Your statutory rights are not affected.
Three Year Warranty
All Datavideo products purchased after July 1st, 2017 are
qualified for a free two years extension to the standard
warranty, providing the product is registered with Datavideo
within 30 days of purchase.
Certain parts with limited lifetime expectancy such as LCD panels, DVD
drives, Hard Drive, Solid State Drive, SD Card, USB Thumb Drive, Lighting,
Camera module, PCIe Card are covered for 1 year.
The three-year warranty must be registered on Datavideo's official
website or with your local Datavideo office or one of its authorized
distributors within 30 days of purchase.

9
Disposal
For EU Customers only - WEEE Marking
This symbol on the product or on its packaging indicates
that this product must not be disposed of with your other
household waste. Instead, it is your responsibility to dispose
of your waste equipment by handing it over to a designated
collection point for the recycling of waste electrical and
electronic equipment. The separate collection and recycling of your waste
equipment at the time of disposal will help to conserve natural resources and
ensure that it is recycled in a manner that protects human health and the
environment. For more information about where you can drop off your waste
equipment for recycling, please contact your local city office, your household
waste disposal service or the shop where you purchased the product.

10
Chapter 1 Introduction
Datavideo TPC-700/TPC-700P is the best assistant for all 3200
switchers, and VGB-2000 presentation system. The SE-3200 and VGB-
2000 Apps that are installed on the TPC-700/TPC-700P contain presets
of common operation functions. Just tap on the screen to easily select
different presets. Each button can be customized to your liking. Multi-
camera Virtual Studio switching, AUX output, Crosspoint, Flex Source,
and PIP assignment can be done by the TPC-700/TPC-700P. Easy to
transport to your live production show on the go. Quick connection.
Simple installation.
1.1 Features
The Touch Panel supports 800 x 480 resolution.
Supports Wall mount installation and complies to standard VESA
dimensions：10cm x 10cm
7” Capacitive Touch Panel
Supports PoE Power Supply(For TPC-700P Only)