DataCard SD260L User manual

SD260LTM/SD360TM/SD460TM
Card Printers
For Printers Using the Datacard
XPS Card Printer Driver
USB and Network
Installation Instructions
Quick Install Guide

Contents
Step 1: Prepare the Printer ................................................................................. 2
Step 2: Plug In and Power On the Printer....................................................... 4
Step 3: Set Up the PC .......................................................................................... 5
Step 4: Install the Printer
(USB): Install a USB Printer ............................................................................ 7
(Network): Install a Network Printer .......................................................... 9
Step 5: Print a Sample Card.............................................................................. 12
The printer must be used as installed and recommended by Datacard. You may not modify the printer or
how it is used without written permission. Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Installation Steps
*Supplies sold separately
Warning: This product contains chemicals, including lead,
known to the State of California to cause cancer, and birth
defects or other reproductive harm. Wash hands after handling.
For more information on this warning, refer to:
www.datacard.com/califpropwarning.

3
2
Step 1: Prepare the Printer
If you are setting up an SD460 system, also refer to
the setup instructions shipped in the laminator carton.
1a
1f
1g
1b
1c
1d
1e

5
4
Step 2: Plug In and Power On the Printer Step 3: Set Up the PC
Network
USB
2a
2b
3a
3b
Do not plug in the USB cable until prompted.

7
6
Step 3: Set Up the PC—cont.
Continue with “Step 4 (USB): Install a USB Printer” on page 7
OR “Step 4 (Network): Install a Network Printer” on page 9.
Step 4 (USB): Install a USB Printer
USB
USB
3c 4a
4b
3d

9
8
Go to “Step 5: Print a Sample Card” on page 12.
Step 4 (USB): Install a USB Printer—cont. Step 4 (Network): Install a Network
Printer
USB
Network
Network
4c
4a
4b
2X

11
10
Step 4 (Network): Install a Network Printer—cont. Step 4 (Network): Install a Network Printer—cont.
Go To “Step 5: Print a Sample Card” on page 12.
Network
Network
Network
4d
4e4c

12
Step 5: Print a Sample Card
Please complete a brief survey about your product installation experience at:
https://www.datacard.com/datacard-product-installation-report
5
1187 Park Place
Shakopee, Minnesota 55379
952.933.1223 • 952.933.7971 Fax
www.datacard.com/id
February 2017 527247-001 Rev H
Datacard is a registered trademark and service mark of Entrust Datacard Corpora-
tion, and Entrust is a registered trademark and service mark, in the United States and
other countries.All other trademarks are the property of their respective owners.
© 2012–2017.The design and information contained in these materials is protected
by US and international copyright law.