Datamax Mark II E-4205e User manual

92-2526-01 Rev.A

Connect Power and
Communications
Serial
Parallel
USB
To Host
LAN (optional)
Power
Connection

Adjust Media
Sensor
(perform only if
equipped with the
optional AMS
feature)
While ensuring the Reference
Letter matches, position the top
and bottom halves of the Media
Sensor over the gap, notch,
or mark in the media.

Load Media
Roll
Media
Printhead
Latch
Printhead
Carrier Media
Hub
Media Hub Flange
(smooth side toward media)
Optional Peeler Latch
Quick Start Guide
For the latest in products, news,
and support visit our web page at
www.datamax-oneil.com
1
2


Load Ribbon
(perform only if
equipped with the
optional
Thermal Transfer
feature)
a) Push the Printhead Latch down
and raise the Printhead Carrier
Assembly.
Printhead
Latch
Printhead
Carrier
b) Remove and load the Hubs:
Ribbon
Empty Core
Slide a Ribbon onto a Hub and
an Empty Core onto a Hub
Push in and lift
to remove the Hubs
c) Replace the Hubs so that the
ribbon flows as shown below:
Note: Ensure the inked side of
the ribbon faces the media
and NOT the printhead.
d) Route the ribbon through the printer, as shown below:
Wrap the end of the ribbon
around the Empty Core
and secure it in place

Printer/User
Interface
Normal Mode
F3
F2
F1 Pauses/Un-pauses the printer.
Cancels thecurrent batch of labels.
Press the Pause button to print the next
batch of labels (if any) in the print buffer.
(Normal power-up)
To calibrate media: Press and hold the until one
complete label has been output then release.
Feeds one label and clears fault conditions.

Printing
Configuration
and Test Labels
With the printer ‘On’ and loaded with 4 inch wide media (and ribbon, if needed):
To print the Configuration Label:
Press the F2 + F3 buttons simultaneously.
To print the Print Test Label:
Press the F1 + F2 buttons simultaneously.
To print the Ethernet/Network Report Label:
Press the F1 + F2 + F3 buttons simultaneously.
Follow and perform the suggested maintenance as detailed in the Operator’s
Manual.
For detailed information on the topics referred to in this guide consult the
Operator’s Manual; for detailed information on custom programming see the
Class Series II Programmer’s Manual (included on the Accessories CD-Rom).
Contacting Datamax-O’Neil…
Corporate Headquarters [phone]
Technical Support [phone]
Website: www.datamax-oneil.com