Datwyler RND lab 560-00226 User manual

Features:
The multi-purpose tool offers an excellent all-round solution, ideal for working on small PCBs,
components, soldering etc.
The magnifying lamp with integrated 3rd hand is intended for illuminating work areas and it
is equipped with a magnifying glass.
The tool also comes with soldering iron stand, alligator clips, soldering wire spool holder,
sponge, rosin, as well as cleaning ball to help with soldering.
It can be powered either by 4 AA batteries(not included) or external power
adaptor(required).
Specifications:
Magnifying glass lens size: 90mm
Magnification: 3Xor(2.5X+4X)
LED illumination: 16 pieces LEDs
Neck (for magnifying glass) length: 265mm
Neck (for alligator clips) length: 250mm
Sponge size: 30x50mm
Rosin :10g
Base size: 190x170mm
Operation Instructions:
Take the lamp out ofthe packaging and place it on a level, even surface.
Adjust the lamp holder and the light-arm as desired.
Insert 4AABatteries or use the power adaptor toget the unit powered up.
Thetool can also bepowered by 4*AA batteries is there's no socket nearby.
Switch on theLED magnifying lamp, then start your operation.
LED Magnifying Lamp with
Third Hand
RND is a trademark of Dätwyler Schweiz AG, Gotthardstrasse 31, 6460 Altdorf, Switzerland, [email protected]

1. Please note the 2 iron sticks are used to hold the soldering wire spool. Before use ,
please unscrew the 2 screws , put the 2 iron sticks vertically , then fix the screws back tight.
2. Open the battery cover on the back side, put 4 1.5V AA batteries(not included) inside, then
put the cover back.
Attention!
The product can only beused indoors, never outdoors. Donot expose tomoisture under any
circumstances.
The product isnot a toy and should bekept out of children's reach.
Do not look directly into thelight source when the lamp isinoperation.
Never look into light sources, such as LED lamps or lasers, through themagnifying glass. This may result in
eye injuries, duetothe optical interaction.
Never leave thelamp without supervision when itis in use.
Check the lamp for damage from time totime. Don’t touch the device ifthe lamp orthe mains
adaptors show any signs of damage. Please switch off the appropriate mains socket and then carefully
pull the mains plug from the socket then take it toa specialist workshop.
Maintenance:
Remove loose particles with clean compressed air and then brush off remaining residues with a
soft fine brush.
Clean the surface with a lens cleaning cloth or a clean, soft and lint-free cloth. Toremove
fingerprints and other fat residues, the cloth can bemoistened with water orlens cleaning solution.
Do not use acid, alcohol or other solvents or rough, fuzzy cloths. Avoid excessive cleaning and
extorting too much pressure.
Never touch the lens with your fingernails or other sharp objects.
Dispose of your used batteries/rechargeable batteries free of charge at your local collection point,
our stores oranywhere where batteries/rechargeable batteries are sold.
Please unscrew the 2
screws first
The 2 iron sticks are used to hold the
soldering wire spool
Notes:
RND is a trademark of Dätwyler Schweiz AG, Gotthardstrasse 31, 6460 Altdorf, Switzerland, [email protected]
LED Magnifying Lamp with
Third Hand
Art. Nr.
RND 560-00226