Daytona LIGHTS DL-RGB4KT User manual
Tech Support: 386-257-1187 www.MetraOnline.com
460 Walker Street, Holly Hill, FL 32117
DL-RGB4KT / DLRGB8KT
Power/Ground
(1) Control Box
(4/8) RGB
Rock Lights
9.8ft
1)Mount control box in a safe dry location. Check clearance before screwing into surface.
2) Mount rock lights, 2 different bases are supplied for flat and curved surfaces. Check
clearance before screwing into surface. Note cable length is 9.8 feet.
3) Connect lights to control box and tighten connections. Avoid pinch points when
routing the cables.
4) Connect loose leads of control box. Red wire to switched +12VDC, and the black wire
to chassis ground.
5) Scan QR code to download and install app.
Lotus Lantern App
1.Home Screen
RGB Color Selector Brightness Adjuster
Frequently used colors
will appear
and save in the top 'Preset' bar.
Pre-selected colors will remain o n the
lower 'Classic' bar.
Function Menu
Scan to download smartphone app
Tech Support: 386-257-1187 www.MetraOnline.com
460 Walker Street, Holly Hill, FL 32117
2. Group Manage Menu
Select the top left corner to bring out the Group Manage
Menu. Find and select the controller to pair. Bluetooth
on the smart device must be switched on.
3. Shake Selection
Select the top right corner to bring out the Settings
Menu. The shake feature will randomly select a color
every time your phone is shaken.
4. Modify Pin Sequence
If red, green, and blue do not match the rock light
illumination, the Pin Sequence, in the settings menu, can
be used to reconfigure the outputs (1). Click (2) to save
wh en configuration is completed.
5. RGB Value Selector
1.
Click to open the RGB Value Selector.
2.
Slide the R - G - B bar to change the RGB value, or press
t he minus '-' or plus '+' buttons to change the RGB value.
3.
Each color has a range of 0 to 255.
4.
Click 'Cancel' or 'OK' when setup completed.
Tech Support: 386-257-1187 www.MetraOnline.com
460 Walker Street, Holly Hill, FL 32117
6. Style
Sel ect the Style button at the bottom to bring
out the pattern menu. This menu allows you to
sel ect from a variety of functions, including static
colors, strobe, and fade. Speed and brightness
can be adjusted with the lower sliders.
Speed
Adjustment
Brightness
adjustment
8. Mic
Select the Mic button at the bottom to bring out the Microphone menu. Using the devices built-in microphone, or external
microphone, the lights will adjust the brightness in sync with the volume of the audio detected.
Android iOS
Select The
Mo
de
Sound
Recording
Enable or
disable the
rhythm function
Select the
music rhythem
Select the mic source
Slide the progress
bar to adjust
the sensitivity
7. Music
Select the Music button to play locally stored music which
the lights will sync to. The brightness and colors will
randomly changed base on the music.
Previous Track
0
0
0
:-. �
Croatia
O 0
Loop Mode
Next Track
Pause/Play
Tech Support: 386-257-1187 www.MetraOnline.com
460 Walker Street, Holly Hill, FL 32117
§15.19
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
(2) This device must accept any interference received, including interference that may cause undesired operation.
§15.21
The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or
modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment. In cases where the manual is provided only in a form other than paper, such as on a computer disk or over the
Internet, the information required by this section may be included in the manual in that alternative form, provided the user can
reasonably be expected to have the capability to access information in that form
§15.105
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator & your body.
Legal Information
This manual suits for next models
1
