www.daytonaudio.com
Assembly:
¾Remove the amplifier PCB from the static protective
sleeve using static protective gloves or wrist band
¾Solder the speaker wires to the PCB at points "A & B"
oThere are polarity marks (L+/- R+/-) printed on the bottom
of the PCB
¾Solder the power leads (if desired) at point "C"
oThere are polarity marks (B+/B-) printed on the bottom of
the PCB
¾Plug the LED ribbon cable into the white two-pin socket
at point "D" and mount the power indicator LED
oPolarity: the anode (+) lead is long, the cathode (-) is short
oClip the leads of the LED to the desired length
oPlug the black LED socket onto the LED leads;
anode to red wire and cathode to black wire
Refer to this diagram if for correct polarity
¾Wrap each speaker wire through a ferrite core; one wrap
per core is all that is required
¾Solder the speaker wires to the speaker terminals
¾Solder an output capacitor across the speaker terminals
in parallel with the speaker wires
¾Connect power via the power leads or DC power jack;
we recommend a 12VDC, 2000mA power supply similar
to Parts Express model 120-052
¾Mount the volume control in the desired location and
connect to the amplifier PCB using the 12" ribbon cable
¾Mount the PCB using adhesive pads or with a zip tie
www.daytonaudio.com
Features:
¾Class-T architecture
¾“Audiophile” Quality Sound
o0.03% THD+N @ 9W, 4Ω
o0.10% IHF-IM @ 1W, 4Ω
o11W @ 4Ω, 0.1% THD+N
o6W @ 8Ω, 0.1% THD+N
¾High Power
o15W @ 4Ω, 10% THD+N
o10W @ 8Ω, 10% THD+N
¾High Efficiency
o81% @ 15W, 4Ω
o90% @ 10W, 8Ω
¾Dynamic Range = 98 dB
¾Over-current protection
¾Over-temperature protection
Package Contents:
(1) Class T Digital Audio Amplifier PCB
(1) Volume control PCB with 12" ribbon cable
(1) LED power indicator with ribbon cable
(2) 12" Speaker Wires (Red & Black)
(2) 12" Power Wires (1 Red & 1 Black)
(2) 12" LED Wires (1 Red & 1 Black)
(2) Ferrite Cores
(2) Output Capacitors
