Deco Lighting DWH-LED User manual

2917 Vail Ave.Commerce, CA 90040 •800-613-3326 •[email protected] •www.getdeco.com
1
INSTALLATION INSTRUCTIONS
Deco Lighting practices a program of continuous product improvement, and as a result product specications change frequently. We reserve the right to change
product specications without notice. Contact Deco for the latest product information.
DWH-LED
Industrial/Vapor Tight LED
1. Read carefully before installing fixture. Retain for future reference.
To prevent electrical shock, turn off electricity at fuse box before proceeding.
2. Failure to follow instructions may result in serious injury or death.
3. Upon receipt the fixture, thoroughly inspect for any freight damage which should be brought to the attention of
the delivery carrier. Compare the catalog description listed on the package slip with the fixture label on the housing to
assure you have received material.
4. This fixture must be wired in accordance with the international electrical code and applicable local codes and
ordinances. Proper grounding is required to insure personal safety. Carefully observe the correct grounding procedure
under installation section.
5. DECO luminaires may be damaged if connected to conduit systems containing water - Article 300-5G of National
Electric Code requires that “Conduits or raceways through which moisture may contact energized live parts shall be
sealed or plugged at either or both ends”.
*Deco Lighting assumes no responsibility for claims arising out of improper or careless handling or installation of this product.
General Wiring Diagram
Electrical Connection
1. Connect BLACK (line) driver lead to voltage supply Line position
(HOT).
2. Connect driver WHITE lead to the NEUTRAL supply position.
3. Connect the GREEN ground lead to the supply ground lead.
If using 0-10V dimming:
4. Connect VIOLET lead to supply POSITIVE dimming lead.
5. Connect GREY lead to the supply NEGATIVE dimming lead.
If NOT using 0-10V dimming:
6. Ensure VIOLET and GREY 0-10V dimming leads are properly
capped.
IMPORTANT SAFETY INSTRUCTIONS

2917 Vail Ave.Commerce, CA 90040 •800-613-3326 •[email protected] •www.getdeco.com
2
INSTALLATION INSTRUCTIONS
Deco Lighting practices a program of continuous product improvement, and as a result product specications change frequently. We reserve the right to change
product specications without notice. Contact Deco for the latest product information.
DWH-LED
Industrial/Vapor Tight LED
Installation:
Exploded View for Reference
*1 set of (2) mounting brackets are included per 4’ section

2917 Vail Ave.Commerce, CA 90040 •800-613-3326 •[email protected] •www.getdeco.com
3
INSTALLATION INSTRUCTIONS
Deco Lighting practices a program of continuous product improvement, and as a result product specications change frequently. We reserve the right to change
product specications without notice. Contact Deco for the latest product information.
DWH-LED
Industrial/Vapor Tight LED
1. Locate drill holes for mounting brackets. Use hardware found in hardware kit. Mount bracket to surface.
2. Rotate Up and Snap other slide of housing into bracket.
3. Install Diffuser once unit is securely installed with brackets.

2917 Vail Ave.Commerce, CA 90040 •800-613-3326 •[email protected] •www.getdeco.com
4
INSTALLATION INSTRUCTIONS
Deco Lighting practices a program of continuous product improvement, and as a result product specications change frequently. We reserve the right to change
product specications without notice. Contact Deco for the latest product information.
DWH-LED
Industrial/Vapor Tight LED
Mounting Options:
Mounting bracket:
Chain & Hook by others: