DeGuard D-122 User manual

#D-122 Instruction Manual
Initial Use
1Anti-clockwise turn the housing of the keypad to get the panel off
2Insert the 9V battery
3Input the code(user code, master code, emergency code) to unlock the door
Insert the batteries
1Take the keypad housing off and insert a new 9V battery
2The red light flashes means you should replace a new battery
Open the door
i. Use user code or master code
1Input your user code or master code (both are 1 to 8 digits) and then press “#” button
2Green light flashes once means the code is right, you can clockwise turn the handle to open the door
3If the code is wrong, the panel will alarm
Ii. Use emergency code
1Press ‘# ’ twice, the yellow light on
2Input emergency code and press ‘#’ to confirm
3Green light flashes once means the code is right, you can clockwise turn the handle to open the door
CAUTION: The preset user code is ‘12345678’, the preset master code is ‘1234’, the preset emergency code is ‘12345678’
Close the door
Turn the handle anticlockwise to close the door.
Dear valued customer:
Thank you for choosing our products! You have
taken an important step in organizing and
protecting your most valued possessions. Every
series of our safes is professionally made and
designed to provide safety. Please take time to
read and familiarize yourself with the proper
operating procedures of your new safe presented
on the following pages.

Automatically locked
1After four continuously wrong input, the panel will lock automatically for 1 minute
2Another continuously wrong input will lock the panel for another 5 minutes
3The panel will return to normal status until you input the right code
CAUTION:The keypad is invalid during the lock status.
Set the user code
1With the door unlocked, input original user code(1 to 8 digits), then press ’#’ button
2With the green light on, press ‘*’ button, the yellow light on(without any follow operations in 8 seconds, the keypad
will exit changing state)
3With both green light and yellow light on, input your new master code and press ‘*’to confirm
4The new code will be confirmed by three beeps and yellow light off
5Four beeps means the new code setting is failed
CAUTION:Test the new user code several times before you close the door;
Set the master code
1With the door unlocked, input original master code(1 to 8 digits), then press ’#’ button
2With the green light on, press ‘*’ button, the yellow light on(without any follow operations in 8 seconds, the keypad
will exit changing state)
3With both green light and yellow light on, input your new master code and press ‘*’to confirm
4The new code will be confirmed by three beeps and yellow light off
5Four beeps means the new code setting is failed
CAUTION:Test the new master code several times before you close the door;
Set the emergency code
1Press ‘#’ twice, the yellow light on(without any follow operations in 8 seconds, the keypad will exit changing state)
2With the yellow light on, input your original emergency code and press ‘#’to confirm, the green light will on
3With the green light on, press ‘*’, the yellow light will on
4With both green light and yellow light on, input the new emergency code and press ‘*’ to confirm
5The new code will be confirmed by three beeps and yellow light off
6Four beeps means the new code setting is failed
CAUTION:Test the new emergency code several times before you close the door;
Reset the user code and master code
1Use the emergency code to open the door, the user code and master code will be reset to preset code automatically