Dell PowerVault NX3000 User manual

Dell™ PowerVault™
NX3000 Systems
Getting Started
With Your System
系统使用入门
Memulai Pengaktifan Sistem Anda
はじめに
시스템 시작 안내서

www.dell.com | support.dell.com
Dell™ PowerVault™
NX3000 Systems
Getting Started
With Your System

Notes, Cautions, and Warnings
NOTE: A NOTE indicates important information that helps you make better use
of your computer.
CAUTION: A CAUTION indicates potential damage to hardware or loss of data if
instructions are not followed.
WARNING: A WARNING indicates a potential for property damage,
personal injury, or death.
____________________
Information in this document is subject to change without notice.
© 2009 Dell Inc. All rights reserved.
ReproductionofthesematerialsinanymannerwhatsoeverwithoutthewrittenpermissionofDellInc.
is strictly forbidden.
Dell, the DELL logo, and PowerVault are trademarks of Dell Inc.; Intel and Xeon are registered
trademarks of Intel Corporation in the U.S. and other countries; Microsoft and Windows are either
trademarks or registered trademarks of Microsoft Corporation in the United States and/or other
countries.
Other trademarks and trade names may be used in this document to refer to either the entities claiming
the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and
trade names other than its own.
Model E02S
Regulatory Type E02S001
April 2009 P/N K187N Rev. A00

Getting Started With Your System 3
Installation and Configuration
WARNING: Before performing the following procedure, review the safety
instructions that came with the system.
Unpacking the System
Unpack your system and identify each item.
Installing the Rails and System in a Rack
Assemble the rails and install the system in the rack following the safety
instructions and the rack installation instructions provided with your system.

4Getting Started With Your System
Optional – Connecting the Keyboard, Mouse, and Monitor
Connect the keyboard, mouse, and monitor (optional).
The connectors on the back of your system have icons indicating which cable
to plug into each connector. Be sure to tighten the screws (if any) on the
monitor's cable connector.
Connecting the Power Cable(s)
Connect the system’s power cable(s) to the system and, if a monitor is used,
connect the monitor’s power cable to the monitor.

Getting Started With Your System 5
Securing the Power Cable(s)
Bend the system power cable(s) into a loop as shown in the illustration and
secure the cable(s) to the bracket using the provided strap.
Plug the other end of the power cable(s) into a grounded electrical outlet or
a separate power source such as an uninterruptible power supply (UPS) or
a power distribution unit (PDU).
Turning On the System
Press the power button on the system and on the optional monitor, if used.
The power indicators should light.

6Getting Started With Your System
Installing the Optional Bezel
Install the bezel (optional).
Supported Operating System
Your system is preinstalled with Microsoft®Windows®Storage Server 2008
Standard x64 Edition.
NOTE: For the latest information on supported operating systems, see www.dell.com
Other Information You May Need
WARNING: See the safety and regulatory information that shipped with
your system. Warranty information may be included within this document or
as a separate document.
• The rack documentation included with your rack solution describes how to
install your system into a rack.
•The
Hardware Owner’s Manual provides information about system features
and describes how to troubleshoot the system and install or replace system
components. This document is available online at
support.dell.com.
• Any media that ships with your system that provides documentation and
tools for configuring and managing your system, including those pertaining
to the operating system, system management software, system updates, and
system components that you purchased with your system.
NOTE: Always check for updates on support.dell.com and read the updates
first because they often supersede information in other documents.

Getting Started With Your System 7
Obtaining Technical Assistance
If you do not understand a procedure in this guide or if the system does not
perform as expected, see your Hardware Owner’s Manual. Dell™offers
comprehensive hardware training and certification. See www.dell.com/training
for more information. This service may not be offered in all locations.
NOM Information (Mexico Only)
The following information is provided on the device described in this
document in compliance with the requirements of the official Mexican
standards (NOM):
Importer:
Model number: E02S
Supply voltage: 100–240 VAC
Frequency: 50/60 Hz
Current consumption: 7.0–3.5A

8Getting Started With Your System
Technical Specifications
Processor
Processor type One or two quad-core Intel®Xeon®Processor 5500
series
Expansion Bus
Bus type PCI Express Generation 2
Expansion slots via riser card:
Riser 1 (Center Riser) One full-height, 9.5-inch length, x4 link (slot 1)
NOTE: This slot can be upgraded to 12.2 inches.
One low-profile, 9.5-inch length, x4 link (slot 2)
Riser 2 (Left Riser) Two full-height, 9.5-inch length, x8 link (slot 3 and 4)
or
One full-height, 9.5-inch length, x16 link (slot 3)
NOTE: Support for up to 25W is available only on the first
two cards installed in the system; any additional cards
installed in the system must be 15W or under.
Memory
Architecture 800, 1066, or 1333 MHz DDR3 registered or unbuffered
Error Correcting Code (ECC) DIMMs. Support for
Advanced ECC or Memory Optimized operation.
Memory module
sockets
Eighteen 240-pin
Memory module
capacities
1 GB or 2 GB UDIMMs and 2 GB, 4 GB,
or 8 GB RDIMMs
(single, dual, or quad-rank dependent on capacity)
Minimum RAM 1 GB with a single processor (1 DIMM per processor)
Maximum RAM 96 GB (with quad-rank 8 GB RDIMM), 144 GB
(with dual-rank 8 GB RDIMM), or 24 GB (with 2 GB
UDIMMs)

Getting Started With Your System 9
Drives
Hard drives Up to six 3.5-inch, internal, hot-swappable SAS or
SATA hard drives without optional internal tape
drive support
Diskette Drive Optional external USB 1.44-MB drive
Optical drive One optional internal slimline SATA DVD-ROM or
DVD+RW drive
Optional external USB DVD
NOTE: DVD devices are data only
Flash Drive Optional internal Secure Digital (SD) memory card
Optional external SD memory card
Connectors
Back
NIC Four RJ-45 10/100/1000 Mbps Ethernet
Serial 9-pin, DTE, 16550-compatible
USB Two 4-pin, USB 2.0-compliant
Video 15-pin VGA
Optional external
VFlash card
One flash memory card slot on the back panel
Front
Video 15-pin VGA
USB Two 4-pin, USB 2.0-compliant
Internal
USB One 4-pin, USB 2.0-compliant
Optional internal
SD module
One internal flash memory card slot
Video
Video type Integrated Matrox G200
Video memory 8 MB shared

10 Getting Started With Your System
Power
AC Power Supply (per power supply)
Wattage 870 W (High Output)
570 W /200840 KB (Energy Smart)
Voltage 90–264 VAC, autoranging, 47-63 Hz
Heat dissipation 2968.6 BTU/hr maximum (High Output)
1944.9 BTU/hr maximum (Energy Smart)
Maximum inrush
current
Under typical line conditions and over the entire system
ambient operating range, the inrush current may
reach 55 A per power supply for 10 ms or less.
Batteries
System battery CR 2032 3.0-V lithium coin cell
RAID battery
(optional)
3.7-V lithium ion battery pack
Physical
Height 8.64 cm (3.4 in)
Width 48.24 cm (18.99 in) with rack latches
44.31 cm (17.4 in) without rack latches
Depth 72.06 cm(28.4 in) with power supplies and bezel
68.07 cm(26.8) without power supplies and bezel
Weight (maximum
configuration)
26.1 kg (57.54 lb)
Weight (empty) 17.7 kg (39 lb)

Getting Started With Your System 11
Environmental
NOTE: For additional information about environmental measurements for specific
system configurations, see www.dell.com/environmental_datasheets
Temperature
Operating 10° to 35°C (50° to 95°F) with a maximum temperature
gradation of 10°C per hour
NOTE: For altitudes above 2950 feet, the maximum operating
temperature is derated 1°F/550 ft.
Storage –40° to 65°C (–40° to 149°F) with a maximum temperature
gradation of 20°C per hour
Relative humidity
Operating 20% to 80% (non-condensing) with a maximum humidity
gradation of 10% per hour
Storage 5% to 95% (non-condensing) with a maximum humidity
gradation of 10% per hour
Maximum vibration
Operating 0.26 Gms from 5–350 Hz for 5 minutes in operational
orientations
Storage 1.54 Gms from 10–250 Hz for 10 minutes in all orientations
Maximum shock
Operating Half sine shock in all operational orientations of 31 G plus
or minus 5% with a pulse duration of 2.6 ms plus or minus
10%
Storage Half sine shock on all six sides of 71 G plus or minus 5%
with a pulse duration of 2 ms plus or minus 10%
Square wave shock on all six sides of 27 G with a velocity
change at 235 in/sec or greater
Altitude
Operating –16 to 3048 m (–50 to 10,000 ft)
NOTE: For altitudes above 2950 feet, the maximum operating
temperature is derated 1°F/550 ft.
Storage –16 to 10,600 m (–50 to 35,000 ft)

12 Getting Started With Your System

www.dell.com | support.dell.com
Dell™ PowerVault™
NX3000 系统
系统使用入门

注、小心和警告
注： “注”表示可以帮助您更好地使用计算机的重要信息。
小心：
“小心”表示如果不遵循说明，就有可能损坏硬件或导致数据丢失。
警告： “警告”表示可能会导致财产损失、人身伤害甚至死亡。
____________________
本说明文件中的信息如有更改，恕不另行通知。
©2009 Dell Inc. 版权所有，翻印必究。
未经 Dell Inc. 面许可，严禁以任何形式复制这些材料。
Dell,、DELL 徽标、和 PowerVault 是Dell Inc. 的商标； Intel 和Xeon 是Intel Corporation 在美
国和其它国家和地区的注册商标； Microsoft 和Windows 是Microsoft Corporation 在美国和 /
或其它国家和地区的商标或注册商标。
本说明文件中述及的其它商标和产品名称是指拥有相应商标和产品名称的公司或其制造的产
品。 Dell Inc. 对本公司的商标和产品名称之外的其它商标和产品名称不拥有任何专有权。
型号 E02S
管制类型 E02S001
2009 年4 月P/N K187N 修订版。 A00

系统使用入门 15
安装和配置
警告：执行下列步 之前，请阅读系统随附的安全说明。
打开系统包装
打开系统包装并识别每件物品。
在机架中安装滑轨和系统
遵循系统随附的安全说明和机架安装说明组装滑轨并在机架 安装系统。
可选连接键盘、鼠标和显示器

16 系统使用入门
连接键盘、鼠标和显示器 （可选）。
系统背面的连接器附有图标，这些图标指示了要插入每个连接器的电缆。
确保拧紧显示器的电缆连接器上的螺钉 （如果有）。
连接电源电缆
将系统电源电缆连接至系统，如果使用显示器，将显示器电源电缆连接至
显示器。
固 电源电缆
如图所示，将系统电源电缆弯曲成一个环路，并使用所提供的带子将其固
定到支架。

系统使用入门 17
将电源电缆的另一端插入接地的电源插座或单独的电源，如不间断电源设
备(UPS) 或配电装置 (PDU)。
开启系统
按下系统和显示器 （如有使用）上的电源按钮。电源指示灯将会亮起。
安装可选挡板
安装挡板 （可选）。

18 系统使用入门
支持的操作系统
系统预安装了 Microsoft®Windows®2008 标准 x64 版存储服务器。
注：有关支持的操作系统的最新信息，请参阅 www.dell.com
可能需要的其它信息
警告：请参阅系统附带的安全与管制信息。保修信息可能包括在该说明文
件中，也可能作为单独的说明文件提供。
• 机架解决方案附带机架说明文件，介绍了如何将系统安装到机架中。
• 《硬件用户手册》提供了有关系统 能的信息，并说明了如何排除系统
故障以及安装或更换系统组件。可在
support.dell.com 在线获取该说明
文件。
• 系统随附的任何介质提供了用于配置和管理系统的说明文件和工具，
包括与随系统购买的操作系统、系统管理软件、系统更新软件以及系
统组件相关的说明文件和工具。
注：请经 访问 support.dell.com 查看是否有更新，并先阅读更新信
息，因为这些更新通 会取代其它说明文件中的信息。
得技术帮助
如果您对本指南 的步骤有疑问，或系统运行无法达到预期效果，请参阅
《硬件用户手册》。Dell®提供全面的硬件培训和认证。有关详情，请参阅
www.dell.com/training。此服务可能并非在所有地区都提供。