Dell PowerVault 120T DLT1 Technical manual

support.dell.comwww.dell.com 03C141 A00
P/N 3C141 Rev. A00
October 2000
Dell™ PowerVault™ 120T
Service Tag/Plate Information Update
This document describes the procedure for removing the service tag from a defective system and
transferring it to your replacement system.
CAUTION: In order to track the future warranty of your Dell purchased system, you must
follow the instructions outlined below. Failure to perform these steps may result in a delay
in future service for your system.
Service Tag/Plate Transfer Procedure
To transfer the Dell service tag/plate to the replacement system:
1. Unpack the replacement system.
2. Shut down the defective system and disconnect the power cable.
3. Locate the service tag/plate on the defective system (see Figure 1).

Figure 1. Locating the Service Tag/Plate
4. Using a #2 phillips screwdriver, remove the two screws securing the service tag/plate to the
back of the defective system.
5. Using the two screws you removed in step 4, secure the service tag/plate to the back of the
replacement system.
6. Connect the power cable to the replacement system.
7. Carefully pack the defective system and return it to Dell.
____________________
Information in this document is subject to change without notice.
© 2000 Dell Computer Corporation. All rights reserved. Printed in the U.S.A.
Trademarks used in this text:
Dell ,the DELL E COM logo, and PowerVault are trademarks of Dell Computer
Corporation. Other trademarks and trade names may be used in this document to refer to either the entities
claiming the marks and names or their products. Dell Computer Corporation disclaims any proprietary interest in
trademarks and trade names other than its own.