dellonda Buxton DG76 User manual

Model No. DG76
Thank you for purchasing a Dellonda product. Manufactured to a high standard, this product will,
if used according to these instructions, and properly maintained, give you years of trouble free performance.
DG76 Issue:1 10/08/21
www.dellonda.co.uk
Dellonda Buxton Rattan Wicker Garden/Outdoor
Dining Chair/Armchair x2

About the Product
Manufactured using dual rattan weave 7mm half round and 5mm round creating the impression of wicker. UV Treated, fade resistant and
weatherproof design can used outside all year round. Chairs supplied with polyester covered cushions. Cushion covers can be removed and hand
washed for easy maintenance. Set includes two chairs. Disclaimer: Colours may slightly vary due to lighting conditions.
• SPECIFICATION
• Model no: ............................................................................................ DG76
• Product dimensions (L x W x H): ...................................... 67 x 64 x 85cm
• Material: ..................................................................... Polyurethane Rattan
Safety Instructions
• Always read these instructions fully before assembling and using your furniture.
• WARNING! Keep all ame and heat sources away from this furniture.
• DO NOT use bleach, alkaline or harsh detergents for cleaning. Soap and warm water are recommended.
• DO NOT use a high-pressure washer to clean this product.
• This product has a reasonable level of protection against UV degradation, however as with any material it will begin to fade and degrade after
long periods of exposure to the sun.
Contents
Assembly
Important Information
Please read these instructions carefully. Note the safe operational requirements, warnings & cautions. Use the product correctly and with care
for the purpose for which it is intended. Failure to do so may cause damage and/or personal injury and will invalidate the warranty. Keep these
instructions safe for future use.
1
www.dellonda.co.uk
Refer to
instruction
manual
• In turn offer up each leg (A) onto the base
frame of the armchair (B) bolt into the frame
with the three M6 x 20mm bolts (C) and the
three M6 washers (D).
• Tighten down with the hex key (E).
• (Retain the hex key (E) to allow you to tighten
these bolts at a later date).
CHAIR LEG CHAIR SEAT M6 X 20MM
BOLT
M6 WASHER HEX KEY

Environment Protection and Waste Protection and Electrical Equipment Regulations (WEEE)
Recycle unwanted packaging materials. When this product is no longer required, or has reached the end of it’s useful life, please dispose of it
in an environmentally friendly way. Drain any fluids (if applicable) into approved containers, in accordance with local waste regulations. It is our
policy to continually improve products and we reserve the right to alter data, specifications and parts without prior notice. No liability is accepted
for incorrect use of this product.
Dellonda Limited
Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757575 [email protected] www.dellonda.co.uk
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
• Carefully turn the armchair onto it’s feet and
position.
• Set the cushions into the chair.
STORAGE
• Ensure that the cushions are clean dry before being stored in a dry and well ventilated location.
• Wipe down the armchairs frame and legs and any areas that could have been exposed to mud and dirt.
• Store the chair in a cool, dry location between use to prolong the usable life of all parts.