Backyard Creations 273-0843 User manual

INSTRUCTION MANUAL: SKU#273-0843 STEEL BENCH WITH FOLDABLE TABLE
CAUTION: Read all instructions before assembly. Failure to do so may result in faulty assembly and potential
injury.
Important information:
1. To put the bench together it is recommended that you have one other person help you.
2. Assemble on a soft, non-abrasive surface, such as carpet or cardboard to avoid damaging the item.
3. Please don’t tighten the bolts too tightly. Fasten nuts and washer to bolt by hand initially. After all parts have been
put together go back and tighten each nut on each bolt to completed installation.
4. For a more satisfying appearance please install with bolt head on the outside of bench parts with the thread on the
inside parts.
5. It is recommended to store the bench under critical weather and use an outdoor cover (sold separately) to extend
the life of the product.
6. For safety, we recommend that you check the bolts regularly and tighten them.
7. The product contains small parts, please keep children away when installing.
Noted: Identify all parts packed in carton against the parts list. Remove all the protective material carefully and DO NOT
use a knife to prevent scratching the surfaces. USE ONLY ON LEVEL SURFACES. INSPECT VISUALLY BEFORE EACH USE
AND ENSURE ALL HARDWARE IS PROPERLY TIGHTENED.
CUSTOMER SERVICE: For questions, assistance or repair parts, please call toll free at: 1-800-505-8305 (M-F 9:00am-
5:00pm Eastern Time) or visit us on the web www.americancustomerservice.com 24 hours a day.
PARTS LIST
REF.
PARTS
NAME
IMAGE
QTY
A
Armrest
2
B
Seat
1
C
Backrest
1
D
Short Bolt
4
E
Long Bolt
4
F
Washer
16
G
Nut
8

H
Nut Cap
8
J
Allen Wrench
1
K
Wrench
1
ASSEMBLY INSTRUCTIONS
STEP ONE: AFFIX SEAT TO ARMREST
•With help of one other person, carefully hold Seat (B) in
place and align with holes in Armrest (A).
•Insert Short Bolt (D), Washer (F) through Armrest (A) and
then Seat (B). Secure with Washer (F) and Nut (G) using the
provided Allen Wrench (J) and Wrench (K).
•Repeat for the other armrest.
STEP TWO: AFFIX BACKREST TO ARMREST
•With help of one other person, carefully hold Backrest (C)
in place and align with holes in armrest (A).
•Insert Long bolt (E), Washer (F) through Armrest (A) and
then Backrest (C). Secure with Washer (F) and Nut (G) using
the provided Allen Wrench (J) and Wrench (K).
•Repeat on the other side.
STEP THREE: PLACE ON LEVEL GROUND
•Tighten all bolts using provided Allen Wrench (J) and
Wrench (K) and put on Nut Cap (H).
•Now your bench is ready to use!
For missing parts, please call toll free customer
service number 1-800-505-8305 (M-F 9:00am-
5:00pm Eastern Time) for further assistance.

HOW TO USE THE MIDDLE TABLE
1. Lift the middle table.
2. Hold the metal bar and lift it.
3. Secure the metal bar in the hooks on both sides
of the middle table.
4. Now your table is ready to use!
BACKYARD CREATIONS® MANUFACTURER‘S WARRANTY (Limited 1-Year Warranty)
This product is covered under the manufacturer’s one year limited warranty against defects in workmanship and materials. If your
product fails structurally during normal use within one year of purchase, the manufacturer will repair or replace the defective unit at
no charge. The warranty excludes furniture used for commercial purposes, furniture damaged by act of nature, abuse or lack of
proper care or corrosion or rusting of metal frame and hardware. Proof of purchase (dated register receipt) and in some cases
photos of the product are required for warranty claims. Maintain your outdoor furniture by using furniture covers and store away
during extreme weather conditions.
SAVE YOUR RECEIPTS. THIS WARRANTY IS VOID WITHOUT THEM.
Test Rite Products Corp. 1900 S. Burgundy Place, Ontario, CA 91761 Made in China