Delta Electronics DTE-20T User manual

DTE Accessory
Instruction Sheet
Thank you very much for choosing DTE-20T. Please read this instruction sheet before using your DTE-20T to ensure proper
operation. Keep this instruction sheet handy for quick reference.
Warning
1. Please hold the plastic terminal when installing DTE-20T to prevent electrostatic discharge (ESD).
2. Prevent dust or metallic debris from falling into the device and cause malfunction. DO NOT modify or uninstall DTE-20T
without being permitted. DO NOT use empty terminals.
3. When installing DTE-20T, please make sure the power of DTE main unit is switched off and insert DTE-20T into the correct
slot on DTE main unit.
4. Make sure you install DTE-20T correctly before switching on the power; otherwise serious damage may occur.
5. DO NOT touch the terminals or repair the device when the power is on; otherwise an electric shock may occur.
Functions & Electrical Specifications
Power consumption Max. 0.5W
Input sensor 4 channels of thermocouple: K, J, T, E, N, R, S, B, L, U, TXK
Sampling cycle Thermocouple: 1.0 second (4 channels)
Terminal connection Can only be inserted into INB slot on DTE10T main unit
 The sensor slot (INA/INB) only accepts the same input type. For example, if you select DTE-20T as accessory, you can only
use it on DTE-10T main unit.
How to Install
1Remove all the terminal
blocks on the panel.
2Uncover the panel. Make
sure which slot is the
correct one and insert
DTE-20T into the slot.
3Cover up the panel. 4Insert the terminal blocks
back
The content of this instruction sheet may be revised without prior notice. Please consult our distributors or
download the most updated version at http://www.delta.com.tw/industrialautomation