Deltech Fitness DF1000 User manual

ASSEMBLY INSTRUCTIONS FOR
THE DF1000 OLYMPIC BENCH
WEIGHT CAPACITY 750 LBS IN
THE FLAT POSITION AND 550
LBS IN THE INCLINE POSITION.
WEIGHT AND USER 100 LB MAX
ON THE LEG DEVELOPER
*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEASE CONTACT DELTECH FITNESS TOLL FREE [phone]
FOR YOUR SAFETY READ ALL INSTRUCTIONS CAREFULLY
[phone]

BOX CONTENTS
*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEASE CONTACT DELTECH FITNESS TOLL FREE [phone]
BACKREST
QTY 1
A
SEAT
QTY 1
B
LEG YOKE
QTY 1
C
WEIGHT HOLDER
QTY 2
D
SEAT SUPPORT
QTY 1
E
BACKREST SUPPORT
QTY 1
F
MAIN FRAME
QTY 1
G
WEIGHT FRAME
QTY 1
HJ
LEG EXTENSION
ARM
QTY 1
INCLINE SUPPORT
QTY 1
K
LEG PAD TUBE
QTY 3
L
LEG PAD
QTY 6
M
HARDWARE
QTY 1 INSTRUCTIONS
I
WEIGHT FRAME
FEET
QTY 1

HARDWARE
2” SQUARE
CAP
QTY 4
N
1-3/4” SQUARE
CAP
QTY 3
O
1-1/2” SQUARE
CAP
QTY 2
P
1” x 2”
CAP
QTY 2
Q
SEAT SUPPORT PIN
QTY 1
U
R
MUSHROOM CAP
QTY 6
RUBBER BUMPER
QTY 1
V
T
SELF LOCKING
TURN KNOB
QTY 1
Z
XY
M12 x 79MM BOLT
QTY 2
WM10 x 25MM BOLT
QTY 10
M12 x 75MM BOLT
QTY 6 M10 x 75MM BOLT
QTY 1
M12 WASHER
QTY 8 M10 WASHER QTY 12 M12 LOCKNUT
QTY 6
AA
M10 LOCKNUT
QTY 1
BB CC DD

SEAT & BACKREST ASSEMBLY
NOTE: THE
SEAM GOES TO
THIS SIDE
USE THE M10 x 25MM BOLTS (Z) AND THE M10 FLAT WASHERS (BB) TO SECURE
THE BACKREST (A) AND THE SEAT (B) TO THE SUPPORTS (E) AND (F).
*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEASE CONTACT DELTECH FITNESS TOLL FREE [phone]
TOOLS REQUIRED:
METRIC WRENCHES OR SOCKET SET
Z
BB
BB
Z
B
A
E
F

BOLT THE LEG EXTENSION ARM (J) TO THE LEG YOKE (C) USING THE M10 x
75MM BOLT (Y) THE M10 FLAT WASHERS, AND THE M10 LOCK NUT (DD).
NEXT SLIDE THE LEG PAD TUBES (L) THROUGH THE LEG EXTENSION (J) AND
THE LEG YOKE (C). THEN SLIDE THE LEG PADS (M) ON TO THE LEG PAD TUBES
(L). INSERT THE MUSHROOM CAPS (R).
*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEASE CONTACT DELTECH FITNESS TOLL FREE [phone]
LEG EXTENSION ASSEMBLY
R
R
R
R
R
R
J
M
M
M
M
M
M
L
L
L
C
Y
DD