Demasled GSM-L10 User manual

USER MANUAL
Technical Parameters
●Working temperature：-20-60
●Supply voltage: DC12V
●Output: 9 channels
●Connecting mode：common anode common cathode
●External dimension：L70 × W45 × H30mm
●Packing dimension：L94 × W64 × H62mm
●Net weight: 77 g ●Gross weight: 115g
●Max output current: 9*0.5 A ●Max output power: 54W
Direction for use
1. Connect the load wires at first, following by the power wires; Please ensure that short
circuit can not occur between connecting wires before you turn on the power
2. In order to receive the infrared control signal normally, it is necessary to ensure that
there is no barrier between the remote control and infrared detector.
3. The key-press functions are shown below:
Number 1 to 9: program choosing button; corresponding to program 1 to program 9
Rapide: speed change button, up direction
Slow: speed change button, down direction
: brightness change button, up direction

. . . . . .
-+
AC110V~230V
-
+
DC12V
power adapter
Output
IR
. .
. .
. . .
DC12V
+
+
Amplifer
.
.
..
.
.
Input
Output
LED STRIP
5M
LED STRIP
5M
. .
.
.
. . . . . . . . .
10Pin
DC12V
+
+
Amplifer
.
.
..
.
.
Input
Output
. . . . . .
. . . . . .
: brightness change button, down direction
Reset: the program back to the program 1; low speed, red color, the highest brightness
ON: open the output OFF: close the output
Left: move to the left Right: move to the right
4. Under the program 1, 2, 3, 4, 5, users can use 7 color buttons: green, blue, red, cyan,
white, purple, yellow on the left side of IR remote panel;
Under the program 1, 2, 5, 7, 8, 9, users can use the button ‘Left’ and ‘Right’ to change the
move direction.
5. Standard changes as the following form (‘Ye s ’and ’No’indicate that the corresponding
items can be changed or not ):
Program Pattern speed
brightness color
move
direction
1 Single color flow form Yes Yes Yes Yes
2 Single color fade in and fade out, flow
form
Yes No Yes Yes
3 Single color fade in and fade out, in
whole
Yes No Yes No
4 Static color No Yes Yes No
5 Single color stroboflash, flow form Yes Yes Yes Yes
6 Seven-color jumpy change Yes Yes No No
7 Seven-color chase change Ye s Ye s No Ye s
8 Three base color chase change Yes Yes No Yes
9 Seven-color flow form Yes Yes No Yes
Attentions:
1. Supply voltage of this product is DC12V; never connect to other sizes of Voltages;
2. Never connect two wires directly in case of short circuit;
3.Load wires should be connected correctly according to the connecting diagram
offers;
4. Don't peel off the label on the controller in case any indication of information will
be missed;
5. Warranty of this product is one year. In this period, we guarantee replacement or
repairing with no charge, but exclude the artificial situation of damaged or overload
working.
Typical Application

Com
G1
R2
R3
B1
G2
G3
R1
B2
B3
INPUT PORT OUTPUT PORT
Interface conncetion