Demonic Machines Signal Driver User manual
Signal Driver
MANUALMANUAL
The SIGNAL DRIVER is a unique
soft-clipping overdrive circuit. It
features internal DIP switches that
give you over 4,000 options for clip-
ping avors and an active 3-band EQ
that can provide up to 10dB of boost
or cut.
CONTROLS
• GAIN controls the level of distor-
tion in the signal. Turn it down
and you can use thism pedal as a
clean boost. Turn it all the way up
and get hella distortion.
• MOJO controls the mojo head-
room and overall sparkliness of the
distortion.
• LEVEL is the volume control.
• LO, MID, & HI provide a boost/
cut to their respective frequencies.
Additionally, the signal driver
has two banks of internal DIP
switches that you can use to
select the clipping diodes. The
switches are as follows:
1. 1N4148 silicon diode
2. 1N4148 silicon diode
3. 2N7002 MOSFET
4. Red LED
5. 1N3666 germanium diode
6. 1N6263 Schottky diode
7. Open/close clipping loop.
In order to function, at least
one switch on each bank must
be in the “OFF”(down) posi-
tion. The following pages have
some suggested settings.
SUPER DISTORTION
GERMANIUM+MOSFET
LED DISTORTION
NO CLIPPING
N.Y.C.B.M.P.
MY SETTINGS
SWITCHING
This pedal features DPDT true relay bypass
switching.
POWER REQUIREMENTS
This machine takes a standard 9 volt DC
power supply with a 2.1mm negative center
barrel. We always recommend pedal-specic,
transformer-isolated wall-wart power sup-
plies or multiple isolated-output supplies.
Pedals will make extra noise if there is ripple
or unclean power. Switching-type power
supplies, daisy chains and nonpedal specic
power supplies do not lter dirty power as
well and let through unwanted noise. DO
NOT RUN AT HIGHER VOLTAGES!
Current draw: ~60mA
WARRANTY
This machine has a limited lifetime warranty.
If it breaks, we will x it. Should you
encounter any issues, please email info@
demonicmachines.com
CHECK US
OUT ONLINE!
https://demonicmachines.com/
Tone is in the signal.
Other Demonic Machines Music Pedal manuals
