Denver Tent Company Colorado Manual

Colorado Wall Tent Set Up Instrucons
Step 2: Remove Couplers, set aside 2, 3-way couplers with hole
drilled in top.
Step 3: Layout out the roof couplers and rails.
-Ends are 3 –way couplers, middle 4-way couplers
MAKE SURE THE 3-WAY COUPLERS WITH HOLE ARE IN
MIDDLE ON FRONT AND REAR
4-way couplers
3-Way Coupler
with Hole
3-Way Couplers
Hole
Step 1: Make Sure you have all that you need.
-Tent Bag
-Couplers Bag
-Ropes and Stakes Bag
-Red, Blue and Yellow Rails
-Hammer, scissors and work gloves

Step 4: Start to construct the roof with the yellow rails
**Yellow are the eaves, Blue are the raers **
Step 5: Finish construcng the roof with the blue rails
**Yellow are the eaves, Blue are the raers **
Blue Raers
Yellow Eaves

Step 7: Tip bag and remove canvas tent and then roll out
along side of tent.
Step 8: Posion Tent along sided of frame top and pull over
top of frame

Step 8: Open Ridge Pole zipper and insert eyebolts through
tent grommet at each end peak.
Step 8: Find your red rails and start to raise the roof. Place
red rails into couplers, this will make the walls.
Start with outsides and move inward

Step 9: Connue on other side
Step 10: Pull Canvas over corner
**only a few inches down**
Step 10: Pull Canvas down leg 6” at a me. Each corner down
6”, then each down another 6” and so on.
**our tents are custom t to each frame so they are ght**

Step 11: Stake all of your grommets
along the boom and all your
eaves grommets (at the top of
your wall) with the ropes and
stakes provided. Make sure
you have all the guy lines
aached for your safety and
security.
For addional informaon:
See our video on Denvertent.com un-
der About-Video Gallery.