Denver TCP-39 User manual

INSTRUCTION MANUAL TCP-39
www.denver-electronics.com
Power Requirement:
Power Consumption: AC 220-240V~50Hz In Use(Max): 8W / HOUR
In Standby/Off: <0.5W / HOUR
LOCATION OF CONTROL
1
2
3
5
7
4
6
8
9
10 11
12
13
14
15 16
17

LOCATION OF CONTROL
GB
CD OPERATION
PROGRAM
Up to 20 tracks can be programmed for disc play in any order.
Be sure to press the “STOP” button before use.
1. Press the RE/PR button, the display will show “P01”.
2. Select desire track by pressing SKIP+ or SKIP-.
3. Press RE/PR button again to confirm.
4. Repeat step 2 & 3 to enter the tracks into program memory.
5. When all desired tracks have been programmed.
Press PLAY/PAUSE button play the program.
6. Press the STOP button twice to terminate the program.
REPEAT
Press the RE/PR button during playing CD, a single track or all
tracks can be repeated.
Each press switches the repeat mode as following :
1 - REPEAT 1
2 - REPEAT ALL
3 - RANDOM
4 - NORMAL PLAYBACK
AC POWER
You can power your portable system by plugging the detachable AC power
cord into the AC inlet at the back of the unit and into a wall AC power outlet.
Check that the rated voltage of your appliance matches your local voltage.
Make sure that the AC power cord is fully inserted into the appliance
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S
GENERAL OPERATION
- At standby mode, press the “STANDBY/FUNCTION” button to switch on the unit.
- Press the “STANDBY/FUNCTION” button once to switch other mode. (CD/ TAPE/FM/AUX-IN.)
- Press and hold the “STANDBY/FUNCTION” button for 2 seconds to switch off the unit in all modes.
- Press the “VOL+” or “VOL-” button to adjust volume level
CLOCK SET
Clock set must be at standby mode.
1.Press and hold the “CLOCK” button 2 seconds, the LCD will show “24H” and flashing
2.Press the “SKIP+” or “SKIP-” button to select “12H” or “24H”, press the “CLOCK” button to
confirm.
3.Adjust the hour by press the “SKIP+” or “SKIP-” button and then press the “CLOCK” button to
confirm.
4.Adjust the minute by press the “SKIP+” or “SKIP-” button and then press the “CLOCK” button
to confirm.
EQ
EQ type: ROCK-JAZZ-POP-CLASSIC-FLAT
Press and hold the “EQ” button 2 seconds to enter EQ setting.
Press the “EQ” button again to choose the correct setting.
Electric and electronic equipment contains materials, components and substances that can be
hazardous to your health and the environment, if the waste material (discarded electric and
electronic equipment) is not handled correctly.
Electric and electronic equipment is marked with the crossed out trash can symbol, seen below.
This symbol signifies that electric and electronic equipment should not be disposed of with other
household waste, but should be disposed of separately.
All cities have established collection points, where electric and electronic equipment can either be
submitted free of charge at recycling stations and other collection sites, or be collected from the
households. Additional information is available at the technical department of your city.
Imported by:
DENVER ELECTRONICS A/S
Stavneagervej 22
DK-8250 Egaa
Denmark
www.facebook.com/denverelectronics
1. FM ANTENNA
2. SKIP+
3. SKIP–
4. M-/RE/PR/CLOCK
5. M+/EQ
6. PLAY/PAUSE/SCAN
7. STOP/MEMO/SLEEP
8. CD DOOR
9. STANDBY/FUNCTION
10. VOL+/–
11. OPEN/CLOSE
12. PAUSE,STOP/EJECT,
FAST FORWARD,REWIND,PLAY
13. LCD DISPLAY
14. CASSETTE DOOR
15. AUX IN JACK
16. PHONE JACK
17. AC INLET
www.facebook.com/denverelectronics
REPEAT 1 REPEAT ALL RANDOM NORMAL
PLAYBACK
REPEAT
ALL
REPEAT 1
RAND
www.denver-electronics.com