DeVilbiss Healthcare drive AQUAJOY PREMIER PLUS User manual

1
USER GUIDE:
AQUAJOY PREMIER PLUS
SIDE FLAP DIVERTERS:
IF YOU HAVE HANDLES ON YOUR BATH, PLEASE ENSURE THAT YOU ATTACH
THE SIDE FLAP DIVERTERS (PLASTIC STRIPS PACKED WITH YOUR BATHLIFT) TO
YOUR BATH HANDLES (IF YOU HAVE THEM). THE SIDE FLAP DIVERTERS WILL
STOP THE SIDES OF THE SEAT FROM JAMMING UNDERNEATH THE BATH
HANDLES.
PUTTING THE BATHLIFT IN THE BATH:
MAKE SURE YOUR AQUAJOY PREMIER PLUS
BATHLIFT IS PLACED AT THE OPPOSITE END
TO THE TAPS.
PLACE THE BATHLIFT BASE FLAT IN THE
BOTTOM OF THE BATH.
SUCTION FEET:
PLEASE MAKE SURE THAT YOUR BATHLIFT
SUCTION FEET ARE STICKING TO THE BOTTOM
OF YOUR BATH.
IF YOU HAVE DIMPLES OR RIPPLES ON YOUR
BATH, YOU MAY NEED EXTRA MIDDLE SUCTION
FEET TO MAKE SURE THE BATHLIFT STICKS TO
THE BATH.
THE REAR SUCTION FEET HAVE AN EASY
RELEASE BAR ATTACHED WHICH WHEN LIFTED
RELEASES THE SUCTION FEET EASILY.
PLEASE CHECK THAT YOUR SUCTION FEET
ARE STICKING TO THE BOTTOM OF YOUR BATH
EVERY TIME BEFORE YOU HAVE A BATH.
FRONT FEET
REAR FEET
REAR SUCTION FEET
(WITH LIFTING BAR)
FRONT SUCTION
FEET

2
PUTTING THE BATHLIFT TOGETHER:
WHEN YOU PUT THE BATHLIFT BACKREST ON THE SEAT
PART, PLEASE MAKE SURE THAT THE GROOVES AND PEGS
ARE PLACED TOGETHER AND COMPLETELY FLAT. PRESS IT
DOWN INTO THE GROOVES BEFORE LIFTING THE BACKREST
(PLEASE SEE THE PICTURES BELOW).
PLACE THE PEGS
INTO THE GROOVES
LIFTING THE BACKREST TO THE RECLINE POSITION:
ONCE THE BACKREST IS ATTACHED TO THE SEAT BASE, LIFT THE BACKREST UP
UNTIL IT HAS RECLINED.
LIFT THE SIDE FLAPS OUTWARDS SO THAT THEY ARE OPEN.
CONNECTING THE HAND CONTROL TO THE CHARGER:
MATCH THE HAND CONTROL CONNECTOR AND THE CHARGER CONNECTOR
TOGETHER. THE HAND CONTROL INDICATOR LIGHT WILL TURN ORANGE TO LET
YOU KNOW IT IS BEING CHARGED. WHEN USING THE HAND CONTROL PLEASE
PRESS THE UP OR DOWN BUTTON CONTINUOUSLY TO RAISE AND LOWER THE
BATHLIFT.
LIFT THE
BACKREST
UPWARDS
LIFT THE
SIDE FLAPS
UP
CHARGING THE HAND CONTROL:
WHEN THE HAND CONTROL IS NOT IN USE LEAVE IT
ON CHARGE ALL OF THE TIME, YOU CAN NOT
OVERCHARGE THE BATTERY HAND CONTROL. THE
CHARGER INDICATOR LIGHT TURNS RED TO LET YOU
KNOW CHARGING IS IN PROGRESS.
2.
GROOVES
PEGS
PRESS IT DOWN TO
SECURE IT IN PLACE

3
CONNECTING THE HAND CONTROL TO THE BATHLIFT:
PUT THE CONNECTOR OF YOUR CHARGED HAND CONTROL AND
THE CONNECTOR ON THE BACK OF THE BATHLIFT TOGETHER.
PUT THE CLIP IN PLACE OVER THE PRONGS ON THE
CONNECTORS (AS SHOW IN THE PICTURES BELOW).
DISCONNECTING THE HAND CONTROL FROM THE BATHLIFT:
REMOVE THE HAND CONTROL FROM THE BATHLIFT BY UNCLIPPING THE CLIP
AND PULL THE HAND CONTROL CONNECTOR AND THE BATHLIFT CONNECTOR
APART.
HOW TO REMOVE THE BATHLIFT FROM THE BATH:
PUSH THE TWO SIDE FLAPS INWARD ONTO THE SEAT.
PUSH THE BACKREST FORWARD SO THAT IT LIES
FLAT ONTO THE SEAT.
WITH THE BACKREST FOLDED FORWARD ONTO THE
BATHLIFT SEAT, LIFT THE BACKREST FROM THE BASE
IN AN UPWARDS MOTION.
TO REMOVE THE SEAT, PLACE ONE HAND ON THE
LIFTING BAR AT THE REAR OF THE BASE AND LIFT TO
RELEASE THE BATHLIFT FROM THE BATH. CONTINUE
TO LIFT AND THE SUCTION FEET AT THE FRONT OF
THE BATHLIFT WILL RELEASE AUTOMATICALLY.
PLACE YOUR OTHER HAND ON THE FRONT OF THE
BATHLIFT AND LIFT IT OUT OF THE BATH.
PUSH DOWN
FOLD IN
LIFT OFF
LIFT OUT
PRESS THE “DOWN” BUTTON ON THE HAND CONTROL
AND TAKE THE BATHLIFT TO ITS LOWEST FULLY
RECLINED POSITION IN THE BATH.
REMOVE THE HAND CONTROL FROM THE BATHLIFT BY
UNCLIPPING THE CLIP AND PULL THE HAND CONTROL
CONNECTOR AND THE BATHLIFT CONNECTOR APART (AS
SHOWN ABOVE).

4
SAFETY PRECAUTIONS
*ENSURE THAT YOU READ AND FULLY UNDERSTAND THESE
INSTRUCTIONS BEFORE OPERATING THE BATHLIFT.
*PLEASE ENSURE THE HAND CONTROL RETENTION CLIP IS ALWAYS
CONNECTED TO THE ACTUATOR DURING USE.
*MAKE SURE THE SUCTION CUPS ARE FIRMLY STUCK TO THE BATH BEFORE
USE.
*ENSURE THAT TRANSFER FLAPS ARE CLEAR OF ANY OBSTRUCTIONS AS
THE SEAT SECTION IS RAISED. PLEASE USE THE SIDE FLAP DIVERTERS
PROVIDED IF YOUR BATH HAS HANDLES ON. FAILURE TO DO THIS COULD
DAMAGE THE BATHLIFT AND WILL AFFECT YOUR WARRANTY.
*BEFORE TAKING A BATH, CARRY OUT A TRIAL RUN TO FAMILIARISE
YOURSELF WITH HOW THE BATHLIFT WORKS.
*THE AQUAJOY PREMIER PLUS MUST ONLY BE USED TO ASSIST ONE PERSON
GETTING IN AND OUT OF THE BATH AT A TIME, DO NOT USE IT FOR ANY OTHER
MEANS.
*ALWAYS CHECK THERE ARE NO OBSTRUCTIONS AROUND OR UNDERNEATH
THE BATHLIFT, INCLUDING YOUR HANDS AND LEGS.
*NEVER RECHARGE THE BATTERY IN THE BATHROOM OR OUTDOORS.
*ALWAYS CHECK THE WATER TEMPERATURE BEFORE BATHING.
*THE USE OF EXCESSIVE AMOUNTS OF BATHING OILS OR SALTS WILL
REQUIRE THE BATHLIFT TO BE CLEANED MORE FREQUENTLY.
CLEANING –BATHLIFT & COVERS
TO CLEAN THE BATHLIFT, SIMPLY USE A NORMAL HOUSEHOLD CLEANER AND
A DAMP CLOTH. THE AQUAJOY PREMIER PLUS BATHLIFT CAN BE USED WITH
OR WITHOUT COVERS. THE STANDARD COVERMATS CAN BE EASILY
REMOVED AND WASHED IN YOUR WASHING MACHINE UP TO A MAXIMUM
TEMPERATURE OF 60°.
WE RECOMMEND THAT YOU WASH YOUR COVER MATS AFTER EVERY TWO TO
THREE BATHS IF POSSIBLE TO AVOID ANY DIRT OR RESIDUE BUILDING UP.
THE OPTIONAL GEL FILLED COVER MAT SET CAN BE EASILY REMOVED &
WASHED WITH SOAPY WATER.