Dewenwils MLC18 User manual

Please pay attention to the warning signs
Read the instructions with caution before operating
and keep it properly
Model: MLC18
[Instruction Manual]
Remote Control Transmitter
RND
D2D NTM
PIR

The motion/light sensor transmitter has the following 4 modes.
Motion Detection Mode: The receiver will be on whenever
the sensor detects motion, whether in day or night.
Night Time Motion Activation Mode: When the transmitter
is in a location with poor light conditions, the receiver will
turn on once the sensor detects motion.
Random Mode: The receiver will randomly turn on and off
when the transmitter is in a location with poor light
conditions.(Note: the interval between turning on/off is no
less than 10 minutes and no more than 2 hours).
Dusk to Dawn Mode: The receiver will turn on at dusk and
off at dawn. Please note the amount of light at the location
of the transmitter.
Function Introduction
PIR
NTM
D2D
RND
Function
Knob Switch
DC 5V power supply port
Please use a power adapter with 3.5 x 1.35mm DC head
Time Delay
Dial Key
Pairing
Button
Battery
case

Note: To activate the desired function, please rotate the knob switch to the
corresponding letter inscribed for that mode.
When using the "PIR" or "NTM" mode, toggle the "Delayed" switch (on the
back of the transmitter) to select the amount of time that the receiver can
remain on after the last detected motion, 1 minute, 5 minutes, 15 minutes
or 30 minutes are available. This switch is inoperative in the "RND" and
"D2D" modes.
Method of using time delay function
Notes: The receiver must be located within 100 feet of the remote transmitter.
Actual functional range may be affected by the following factors: weather,
radio frequency interference, low remote battery, and obstructions between
the transmitter and receiver.
Operating Instructions
1. Remove the battery cover on the rear side of the transmitter. Insert 3
"AAA" batteries according to the (+) and (-) instructions on the inside of
the battery compartment, and re-install the battery cover. Recommended
to use "NiMH batteries"
2.Plug the receiver into a powered outlet.
3.Plug your device into the socket of the receiver.

Mounting the Transmitter Bracket
1.Install the transmitter mounting bracket in the desired location with the
included screws.
Note: The installation height of the transmitter from the ground should not
be less than 3ft and not more than 7ft.
5FT

2.Select the desired mode.
3.Hang the transmitter on the fixed bracket.
If you find that the receiver does not work properly or the transmitter does
not work, please replace the batteries. Recommended to use "NiMH
batteries".
Replacing Battery
RND
D2D NTM
PIR

- Transmission Frequency: 433.92MHz
- Remote Control Distance: 100 ft (Free Area)
- Detecting Angle:120°
- Detection distance:20ft
Specifications:
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions:
1) this device may not cause harmful interference, and 2) this device must
accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible
for compliance could void your authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
FCC STATEMENT
This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
Note:
1.Do not mix old and new batteries.
2.Do not mix Alkaline Batteries, Super Heavy Duty Batteries (Zinc-Carbon)
or Rechargeable Batteries (NiCd, NiMH, etc.) together.
滚滚长江东逝水
滚滚长江东逝水
● Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
● Consult the dealer or an experienced radio/TV technician for help.
·
● Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.

One Year Limited Warranty
Supported by our professional R&D team and QCteam, we provide One
Year Warranty for materials and workmanship from the purchase date.
Please note that the warranty does not cover damage caused by personal
misuse or improper installation.
Please attach your Order ID and Name so that our dedicated customer
service team can help you better.
ISEDC Warning:
This device complies with Innovation, Science, and Economic Development
Canad licence-exempt RSS standard(s). Operation is subject to the following
two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d' Innovation, Sciences et
Développement économique Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
The device is compliance with RF exposure guidelines, users can obtain
Canadian information on RF exposure and compliance.
Le présent appareil est conforme
Après examen de ce matériel aux conformité ou aux limites d’intensité de
champ RF,les utilisateurs peuvent sur l’exposition aux radiofréquences et
la conformité and compliance d’acquérir les informations correspondantes.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment.